Is Pike Water, Inc.-Ross 2 Tap Water Safe? Quality Report

Water source: GWP
Ownership: Private
Counties served: Pike

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
Other	Monitoring	Unaddressed	2025-11-19
Other	Monitoring	Unaddressed	2024-09-12
Other	Monitoring	Resolved	2021-07-01
Other	Monitoring	Resolved	2021-07-01
Other	Monitoring	Unaddressed	2021-01-04
Other	Monitoring	Unaddressed	2020-02-04
Other	Monitoring	Resolved	2015-07-01
Other	Monitoring	Resolved	2015-07-01
Other	Monitoring	Resolved	2011-07-01
Other	Monitoring	Resolved	2011-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Copper	1160 µg/L 89% of the EPA limit 1300 µg/L worst single sample: 1290 µg/L	26/40	SYR4	2012–2019
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	24/24	LCR	2025
Bromodichloromethane	8.0375 µg/L No EPA limit set worst single sample: 8.42 µg/L	16/16	SYR4	2013–2019
Bromoform	1.0025 µg/L No EPA limit set worst single sample: 1.01 µg/L	16/16	SYR4	2013–2019
Chloroform	10.875 µg/L No EPA limit set worst single sample: 11.4 µg/L	16/16	SYR4	2013–2019
Dibromochloromethane	5.275 µg/L No EPA limit set worst single sample: 5.83 µg/L	16/16	SYR4	2013–2019
TTHM	24.95 µg/L 31% of the EPA limit 80 µg/L worst single sample: 26.6 µg/L	16/16	SYR4	2013–2019
Dichloroacetic Acid	3.451 µg/L No EPA limit set worst single sample: 3.5 µg/L	15/16	SYR4	2013–2019
Trichloroacetic Acid	1.6 µg/L No EPA limit set	15/16	SYR4	2013–2019
Dibromoacetic Acid	1.428 µg/L No EPA limit set worst single sample: 1.44 µg/L	7/16	SYR4	2013–2019
Total Haloacetic Acids (HAA5)	6.317 µg/L 11% of the EPA limit 60 µg/L worst single sample: 6.33 µg/L	3/16	SYR4	2013–2019

3 contaminants tested, none detected

LeadMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact: CAUDILL, BERLIN
Phone: 740-947-2524
Email: [email protected]

Frequently asked questions about Pike Water, Inc.-Ross 2

Is Pike Water, Inc.-Ross 2 tap water safe to drink?

EPA monitoring detected 11 contaminants in Pike Water, Inc.-Ross 2's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Pike Water, Inc.-Ross 2's water?

EPA monitoring detected Copper, Lead, Bromodichloromethane, Bromoform, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Pike Water, Inc.-Ross 2 serve?

Pike Water, Inc.-Ross 2 reports serving 873 people in Ohio, per its EPA record.

Has Pike Water, Inc.-Ross 2 had any water quality violations?

The EPA has 19 violations on file for Pike Water, Inc.-Ross 2, of which 0 are health-based (a contaminant limit or required treatment was breached) and 4 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.