Is Oakwood Village Tap Water Safe? Quality Report

Water source: Ground water
Ownership: Local government
Counties served: Paulding

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

155

violations on file

still open

Violation	Type	Status	Period
TT	Health-based	Resolved	2024-10-17
TT	Health-based	Resolved	2024-10-17
TT	Health-based	Resolved	2024-10-17
TT	Health-based	Resolved	2024-10-17
TT	Health-based	Resolved	2023-07-01
TT	Health-based	Resolved	2023-07-01
TT	Health-based	Resolved	2023-07-01
TT	Health-based	Resolved	2023-07-01
TT	Health-based	Resolved	2023-07-01
TT	Health-based	Resolved	2023-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Bromodichloromethane	13 µg/L No EPA limit set worst single sample: 21.6 µg/L	31/31	SYR4	2012–2019
Bromoform	17.15 µg/L No EPA limit set worst single sample: 20.4 µg/L	31/31	SYR4	2012–2019
Chloroform	8.1 µg/L No EPA limit set worst single sample: 11.6 µg/L	31/31	SYR4	2012–2019
Dibromochloromethane	19.65 µg/L No EPA limit set worst single sample: 32.9 µg/L	31/31	SYR4	2012–2019
Dibromoacetic Acid	6.56 µg/L No EPA limit set worst single sample: 9.9 µg/L	29/29	SYR4	2012–2019
TTHM	55.28 µg/L 69% of the EPA limit 80 µg/L worst single sample: 83 µg/L	29/29	SYR4	2012–2019
Dichloroacetic Acid	3.84 µg/L No EPA limit set worst single sample: 6.6 µg/L	27/29	SYR4	2012–2019
Lead	0.0052 mg/L 35% of the EPA limit 0.0150 mg/L	27/27	LCR	2025
Total Haloacetic Acids (HAA5)	15 µg/L 25% of the EPA limit 60 µg/L worst single sample: 25.3 µg/L	26/29	SYR4	2012–2019
Trichloroacetic Acid	4.35 µg/L No EPA limit set worst single sample: 4.6 µg/L	26/29	SYR4	2012–2019
Copper	107 µg/L 8.2% of the EPA limit 1300 µg/L worst single sample: 120 µg/L	23/31	SYR4	2013–2019
Barium	125.05 µg/L 6.3% of the EPA limit 2000 µg/L worst single sample: 130 µg/L	4/4	SYR4	2013–2019
Fluoride	2289.5 µg/L 57% of the EPA limit 4000 µg/L worst single sample: 2300 µg/L	4/4	SYR4	2013–2019
Lead	18.7 µg/L 125% of the EPA limit, at the 95th percentile of samples — 15 µg/L worst single sample: 19 µg/L	2/31	SYR4	2013–2019
Monobromoacetic Acid	1.775 µg/L No EPA limit set worst single sample: 1.8 µg/L	2/29	SYR4	2012–2019
Nitrate	230 µg/L 2.3% of the EPA limit 10000 µg/L	2/18	SYR4	2012–2019
Carbon Tetrachloride	0.9900 µg/L 20% of the EPA limit 5 µg/L	1/5	SYR4	2013–2019
Chromium	11 µg/L 11% of the EPA limit 100 µg/L	1/4	SYR4	2013–2019
Combined Radium (-226 And -228)	2.4 pCi/L 48% of the EPA limit 5 pCi/L	1/2	SYR4	2013–2019
Monochloroacetic Acid	2.4 µg/L No EPA limit set	1/29	SYR4	2012–2019
Nitrate-Nitrite	230 µg/L 2.3% of the EPA limit 10000 µg/L	1/9	SYR4	2012–2019
Selenium	4.1 µg/L 8.2% of the EPA limit 50 µg/L	1/4	SYR4	2013–2019
Toluene	28 µg/L 2.8% of the EPA limit 1000 µg/L	1/5	SYR4	2013–2019

31 contaminants tested, none detected

1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicAsbestosAtrazineBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumDichloromethaneEthylbenzeneLassoMercuryNitriteSimazineStyreneTetrachloroethyleneThallium, TotalTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact: HENKE, BUD
Phone: 419-594-3359
Email: [email protected]

Frequently asked questions about Oakwood Village

Is Oakwood Village tap water safe to drink?

EPA monitoring detected 23 contaminants in Oakwood Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Oakwood Village's water?

EPA monitoring detected Bromodichloromethane, Bromoform, Chloroform, Dibromochloromethane, Dibromoacetic Acid, and others. The full list with the level and data source for each is above.

How many people does Oakwood Village serve?

Oakwood Village reports serving 727 people in Ohio, per its EPA record.

Has Oakwood Village had any water quality violations?

The EPA has 155 violations on file for Oakwood Village, of which 29 are health-based (a contaminant limit or required treatment was breached) and 4 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.