Tap WaterIndex

← New York

Tap water quality report

M & H Mhp, Llc

EPA monitoring tested this supplier for 52 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

52
contaminants tested
16
detected
55
people served
23
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
Ground water
Ownership
Private
Counties served
Morrow

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

23
health-based violations
336
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2014-04-01 → 2014-06-30
MCL Health-based Resolved 2014-04-01 → 2014-06-30
MCL Health-based Resolved 2014-04-01 → 2014-06-30
MCL Health-based Resolved 2014-04-01 → 2014-06-30
MCL Health-based Resolved 2014-01-01 → 2014-03-31
MCL Health-based Resolved 2014-01-01 → 2014-03-31
MCL Health-based Resolved 2014-01-01 → 2014-03-31
MCL Health-based Resolved 2014-01-01 → 2014-03-31
MCL Health-based Resolved 2013-10-01 → 2013-12-31
MCL Health-based Resolved 2013-10-01 → 2013-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 20/20 LCR 2025
Chloroform
30.375 µg/L
No EPA limit set
worst single sample: 92.4 µg/L
16/18 SYR4 2012–2019
Bromodichloromethane
29.345 µg/L
No EPA limit set
worst single sample: 64.9 µg/L
14/18 SYR4 2012–2019
Dibromochloromethane
20.925 µg/L
No EPA limit set
worst single sample: 42.1 µg/L
12/18 SYR4 2012–2019
TTHM
114.355 µg/L 143%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 225.4 µg/L
12/17 SYR4 2012–2019
Copper
85.75 µg/L 6.6%
of the EPA limit 1300 µg/L
worst single sample: 90 µg/L
6/20 SYR4 2012–2019
Dichloroacetic Acid
125.625 µg/L
No EPA limit set
worst single sample: 165.3 µg/L
6/17 SYR4 2012–2019
Bromoform
20.934 µg/L
No EPA limit set
worst single sample: 26 µg/L
5/18 SYR4 2012–2019
Fluoride
749.2 µg/L 19%
of the EPA limit 4000 µg/L
worst single sample: 751 µg/L
3/3 SYR4 2012–2018
Trichloroacetic Acid
14.21 µg/L
No EPA limit set
worst single sample: 15.6 µg/L
3/17 SYR4 2012–2019
Barium
61.8 µg/L 3.1%
of the EPA limit 2000 µg/L
worst single sample: 62 µg/L
2/3 SYR4 2012–2018
Lead
2.955 µg/L 20%
of the EPA limit 15 µg/L
worst single sample: 3 µg/L
2/20 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
7.94 µg/L 13%
of the EPA limit 60 µg/L
worst single sample: 8.3 µg/L
2/16 SYR4 2012–2019
Dibromoacetic Acid
23.6 µg/L
No EPA limit set
 1/17 SYR4 2012–2019
Monobromoacetic Acid
9.5 µg/L
No EPA limit set
 1/17 SYR4 2012–2019
Monochloroacetic Acid
35.4 µg/L
No EPA limit set
 1/17 SYR4 2012–2019
36 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicAtrazineBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneEthylbenzeneLassoMercuryNitrateNitrate-NitriteNitriteSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
DUCHONOVIC, ROBERT
Phone
917-376-5680
Email
[email protected]

Frequently asked questions about M & H Mhp, Llc

Is M & H Mhp, Llc tap water safe to drink?

EPA monitoring detected 16 contaminants in M & H Mhp, Llc's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in M & H Mhp, Llc's water?

EPA monitoring detected Lead, Chloroform, Bromodichloromethane, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does M & H Mhp, Llc serve?

M & H Mhp, Llc reports serving 55 people in New York, per its EPA record.

Has M & H Mhp, Llc had any water quality violations?

The EPA has 336 violations on file for M & H Mhp, Llc, of which 23 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.