Tap WaterIndex

← Ohio

Tap water quality report

Wadsworth City

EPA monitoring tested this supplier for 82 contaminants and detected 18. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

82
contaminants tested
18
detected
24,356
people served
0
health-based violations
Ohio rankingsLead in OhioPFAS in Ohio
Water source
Ground water
Ownership
Local government
Counties served
Medina

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
5
violations on file
1
still open
ViolationTypeStatusPeriod
Other Monitoring Unaddressed 2018-11-07
MR Monitoring Resolved 2011-04-01 → 2011-04-30
MR Monitoring Resolved 2011-04-01 → 2011-04-30
MR Monitoring Resolved 2011-04-01 → 2011-04-30
MR Monitoring Resolved 2011-04-01 → 2011-04-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
110 µg/L 8.5%
of the EPA limit 1300 µg/L
worst single sample: 150 µg/L
50/64 SYR4 2012–2017
Bromodichloromethane
11.59 µg/L
No EPA limit set
worst single sample: 13.4 µg/L
38/38 SYR4 2012–2019
Chloroform
8.75 µg/L
No EPA limit set
worst single sample: 10.9 µg/L
38/38 SYR4 2012–2019
TTHM
39.18 µg/L 49%
of the EPA limit 80 µg/L
worst single sample: 44.8 µg/L
38/38 SYR4 2012–2019
Dibromochloromethane
11.78 µg/L
No EPA limit set
worst single sample: 13.9 µg/L
35/38 SYR4 2012–2019
Bromoform
6.66 µg/L
No EPA limit set
worst single sample: 7.2 µg/L
29/38 SYR4 2012–2019
Dibromoacetic Acid
3.327 µg/L
No EPA limit set
worst single sample: 3.93 µg/L
24/37 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 23/23 LCR 2025
Dichloroacetic Acid
3.88 µg/L
No EPA limit set
worst single sample: 4.06 µg/L
16/37 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
17.275 µg/L 29%
of the EPA limit 60 µg/L
worst single sample: 18.4 µg/L
16/37 SYR4 2012–2019
Lead
8.45 µg/L 56%
of the EPA limit 15 µg/L
worst single sample: 9.5 µg/L
7/64 SYR4 2012–2017
Fluoride
982.5 µg/L 25%
of the EPA limit 4000 µg/L
worst single sample: 992 µg/L
3/3 SYR4 2012–2018
Monobromoacetic Acid
1.482 µg/L
No EPA limit set
worst single sample: 1.49 µg/L
3/37 SYR4 2012–2019
Barium
21.8 µg/L 1.1%
of the EPA limit 2000 µg/L
worst single sample: 22 µg/L
2/3 SYR4 2012–2018
Monochloroacetic Acid
8.2115 µg/L
No EPA limit set
worst single sample: 8.24 µg/L
2/37 SYR4 2012–2019
Nitrate
550 µg/L 5.5%
of the EPA limit 10000 µg/L
 2/16 SYR4 2012–2019
Nitrate-Nitrite
550 µg/L 5.5%
of the EPA limit 10000 µg/L
 1/7 SYR4 2012–2019
Trichloroacetic Acid
1.21 µg/L
No EPA limit set
 1/37 SYR4 2012–2019
64 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAtrazineBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneEthylbenzeneHfpo-DaLassoMercuryNetfosaaNfdhaNmefosaaNitritePfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
MOORE, DANA S
Phone
330-335-2832
Email
[email protected]

Frequently asked questions about Wadsworth City

Is Wadsworth City tap water safe to drink?

EPA monitoring detected 18 contaminants in Wadsworth City's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Wadsworth City's water?

EPA monitoring detected Copper, Bromodichloromethane, Chloroform, TTHM, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Wadsworth City serve?

Wadsworth City reports serving 24,356 people in Ohio, per its EPA record.

Has Wadsworth City had any water quality violations?

The EPA has 5 violations on file for Wadsworth City, of which 0 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.