Tap WaterIndex

← Ohio

Tap water quality report

Wellington Village

EPA monitoring tested this supplier for 84 contaminants and detected 19. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

84
contaminants tested
19
detected
4,802
people served
19
health-based violations
Ohio rankingsLead in OhioPFAS in Ohio
Water source
Surface water
Ownership
Local government
Counties served
Lorain

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

19
health-based violations
87
violations on file
1
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2017-07-01 → 2017-09-30
MCL Health-based Resolved 2017-07-01 → 2017-09-30
MCL Health-based Resolved 2017-07-01 → 2017-09-30
MCL Health-based Resolved 2017-07-01 → 2017-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-04-01 → 2014-06-30
MCL Health-based Resolved 2014-04-01 → 2014-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
18.8 µg/L
No EPA limit set
worst single sample: 21.8 µg/L
70/70 SYR4 2012–2019
Chloroform
76.965 µg/L
No EPA limit set
worst single sample: 88 µg/L
70/70 SYR4 2012–2019
Dibromochloromethane
6.355 µg/L
No EPA limit set
worst single sample: 7.4 µg/L
70/70 SYR4 2012–2019
Copper
59.9 µg/L 4.6%
of the EPA limit 1300 µg/L
worst single sample: 287 µg/L
67/93 SYR4 2012–2019
TTHM
97.55 µg/L 122%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 117.8 µg/L
63/63 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
37.44 µg/L 62%
of the EPA limit 60 µg/L
worst single sample: 40.5 µg/L
63/63 SYR4 2012–2019
Trichloroacetic Acid
16.07 µg/L
No EPA limit set
worst single sample: 19.9 µg/L
63/63 SYR4 2012–2019
Dichloroacetic Acid
20.5 µg/L
No EPA limit set
worst single sample: 21.8 µg/L
62/62 SYR4 2012–2019
Lead
17.15 µg/L 114%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 22 µg/L
40/93 SYR4 2012–2019
Lead
0.0024 mg/L 16%
of the EPA limit 0.0150 mg/L
 30/30 LCR 2026
Nitrate
290 µg/L 2.9%
of the EPA limit 10000 µg/L
 16/190 SYR4 2012–2019
Bromoform
0.7000 µg/L
No EPA limit set
 15/70 SYR4 2012–2019
Monochloroacetic Acid
3.75 µg/L
No EPA limit set
worst single sample: 4.2 µg/L
11/63 SYR4 2012–2019
Dibromoacetic Acid
1.92 µg/L
No EPA limit set
worst single sample: 2 µg/L
9/63 SYR4 2012–2019
Barium
29.6 µg/L 1.5%
of the EPA limit 2000 µg/L
worst single sample: 31 µg/L
8/8 SYR4 2012–2019
Fluoride
2451 µg/L 61%
of the EPA limit 4000 µg/L
worst single sample: 3200 µg/L
8/8 SYR4 2012–2019
Nitrate-Nitrite
279.5 µg/L 2.8%
of the EPA limit 10000 µg/L
worst single sample: 290 µg/L
8/95 SYR4 2012–2019
Monobromoacetic Acid
1 µg/L
No EPA limit set
 1/63 SYR4 2012–2019
Nitrite
130 µg/L 13%
of the EPA limit 1000 µg/L
 1/91 SYR4 2012–2019
65 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAsbestosAtrazineBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneEthylbenzeneGross Beta Particle ActivityHfpo-DaLassoMercuryNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
LOVE, JON
Phone
440-647-1545
Email
[email protected]

Frequently asked questions about Wellington Village

Is Wellington Village tap water safe to drink?

EPA monitoring detected 19 contaminants in Wellington Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Wellington Village's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, Copper, TTHM, and others. The full list with the level and data source for each is above.

How many people does Wellington Village serve?

Wellington Village reports serving 4,802 people in Ohio, per its EPA record.

Has Wellington Village had any water quality violations?

The EPA has 87 violations on file for Wellington Village, of which 19 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.