← New York

Tap water quality report

Wolcott Village

EPA monitoring tested this supplier for 73 contaminants and detected 19. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

73
contaminants tested
19
detected
2,200
people served
23
health-based violations
Water source
Surface water
Ownership
Local government
Counties served
Wayne

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

23
health-based violations
159
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2011-03-01 → 2011-03-31
TT Health-based Resolved 2011-03-01 → 2011-03-31
TT Health-based Resolved 2011-03-01 → 2011-03-31
TT Health-based Resolved 2011-03-01 → 2011-03-31
TT Health-based Resolved 2011-01-01 → 2011-01-31
TT Health-based Resolved 2011-01-01 → 2011-01-31
TT Health-based Resolved 2011-01-01 → 2011-01-31
TT Health-based Resolved 2011-01-01 → 2011-01-31
TT Health-based Resolved 2004-05-20
TT Health-based Resolved 2004-05-20

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Fluoride
1500 µg/L 38%
of the EPA limit 4000 µg/L
worst single sample: 2400 µg/L
157/159 SYR4 2012–2019
Bromodichloromethane
16 µg/L
No EPA limit set
worst single sample: 17 µg/L
36/37 SYR4 2012–2019
Chloroform
38 µg/L
No EPA limit set
worst single sample: 41 µg/L
36/37 SYR4 2012–2019
Dibromochloromethane
8.125 µg/L
No EPA limit set
worst single sample: 8.7 µg/L
36/37 SYR4 2012–2019
TTHM
62.25 µg/L 78%
of the EPA limit 80 µg/L
worst single sample: 68 µg/L
36/37 SYR4 2012–2019
Dichloroacetic Acid
10.45 µg/L
No EPA limit set
worst single sample: 22 µg/L
32/37 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
20.835 µg/L 35%
of the EPA limit 60 µg/L
worst single sample: 29 µg/L
32/37 SYR4 2012–2019
Nitrate
3195 µg/L 32%
of the EPA limit 10000 µg/L
worst single sample: 3300 µg/L
28/32 SYR4 2012–2019
Trichloroacetic Acid
11.85 µg/L
No EPA limit set
worst single sample: 12 µg/L
24/37 SYR4 2012–2019
Bromoform
2.5 µg/L
No EPA limit set
worst single sample: 3.4 µg/L
22/37 SYR4 2012–2019
Barium
230.9 µg/L 12%
of the EPA limit 2000 µg/L
worst single sample: 236 µg/L
18/18 SYR4 2012–2019
Chromium
7.745 µg/L 7.7%
of the EPA limit 100 µg/L
worst single sample: 10 µg/L
12/18 SYR4 2012–2019
Lead
0.0026 mg/L 17%
of the EPA limit 0.0150 mg/L
9/9 LCR 2023
Monochloroacetic Acid
5.45 µg/L
No EPA limit set
worst single sample: 5.9 µg/L
7/37 SYR4 2012–2019
Dibromoacetic Acid
1.525 µg/L
No EPA limit set
worst single sample: 1.6 µg/L
6/37 SYR4 2012–2019
Cyanide
19 µg/L 9.5%
of the EPA limit 200 µg/L
1/18 SYR4 2012–2019
Combined Radium (-226 And -228)
0.8900 pCi/L 18%
of the EPA limit 5 pCi/L
1/4 SYR4 2017
Monobromoacetic Acid
4.1 µg/L
No EPA limit set
1/37 SYR4 2012–2019
Nitrate-Nitrite
3000 µg/L 30%
of the EPA limit 10000 µg/L
1/2 SYR4 2016
54 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WAZINSKI, III, EDWARD
Phone
315-594-2302

Frequently asked questions about Wolcott Village

Is Wolcott Village tap water safe to drink?

EPA monitoring detected 19 contaminants in Wolcott Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Wolcott Village's water?

EPA monitoring detected Fluoride, Bromodichloromethane, Chloroform, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does Wolcott Village serve?

Wolcott Village reports serving 2,200 people in New York, per its EPA record.

Has Wolcott Village had any water quality violations?

The EPA has 159 violations on file for Wolcott Village, of which 23 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.