Tap WaterIndex

← New York

Tap water quality report

Antlers at Diamond Point

EPA monitoring tested this supplier for 70 contaminants and detected 14. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

70
contaminants tested
14
detected
125
people served
3
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
Surface water
Ownership
Private
Counties served
Warren

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
170
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 1993-06-30 → 2001-09-30
TT Health-based Resolved 1993-06-29
TT Health-based Resolved 1993-06-29
MON Monitoring Resolved 2026-02-01 → 2026-02-28
MON Monitoring Resolved 2026-02-01 → 2026-02-28
MON Monitoring Resolved 2026-02-01 → 2026-02-28
MON Monitoring Resolved 2025-01-01 → 2025-01-31
MON Monitoring Resolved 2025-01-01 → 2025-01-31
MON Monitoring Resolved 2025-01-01 → 2025-01-31
MR Monitoring Resolved 2023-01-01 → 2023-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
7.896 µg/L
No EPA limit set
worst single sample: 8.16 µg/L
9/9 SYR4 2012–2019
Chloroform
73.2 µg/L
No EPA limit set
worst single sample: 74 µg/L
9/9 SYR4 2012–2019
Dichloroacetic Acid
11.16 µg/L
No EPA limit set
worst single sample: 13 µg/L
9/9 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 9/9 LCR 2024
TTHM
80.96 µg/L 101%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 81 µg/L
9/9 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
34.8 µg/L 58%
of the EPA limit 60 µg/L
worst single sample: 36 µg/L
9/9 SYR4 2012–2019
Trichloroacetic Acid
26.95 µg/L
No EPA limit set
worst single sample: 28 µg/L
8/9 SYR4 2012–2019
Barium
9.4 µg/L 0.5%
of the EPA limit 2000 µg/L
worst single sample: 10 µg/L
7/7 SYR4 2012–2019
Fluoride
137.5 µg/L 3.4%
of the EPA limit 4000 µg/L
worst single sample: 139 µg/L
6/7 SYR4 2012–2019
Nitrate
277 µg/L 2.8%
of the EPA limit 10000 µg/L
 6/16 SYR4 2012–2019
Dibromochloromethane
0.7850 µg/L
No EPA limit set
worst single sample: 0.7900 µg/L
3/9 SYR4 2012–2019
Arsenic
0.3000 µg/L 3%
of the EPA limit 10 µg/L
 2/7 SYR4 2012–2019
Combined Radium (-226 And -228)
1.02 pCi/L 20%
of the EPA limit 5 pCi/L
 1/1 SYR4 2017
Selenium
0.4000 µg/L 0.8%
of the EPA limit 50 µg/L
 1/7 SYR4 2012–2019
56 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
SHERRY, GREGG
Phone
518-668-9745
Email
[email protected]

Frequently asked questions about Antlers at Diamond Point

Is Antlers at Diamond Point tap water safe to drink?

EPA monitoring detected 14 contaminants in Antlers at Diamond Point's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Antlers at Diamond Point's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dichloroacetic Acid, Lead, TTHM, and others. The full list with the level and data source for each is above.

How many people does Antlers at Diamond Point serve?

Antlers at Diamond Point reports serving 125 people in New York, per its EPA record.

Has Antlers at Diamond Point had any water quality violations?

The EPA has 170 violations on file for Antlers at Diamond Point, of which 3 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.