Tap WaterIndex

← New York

Tap water quality report

Hillside Acres Water Company

EPA monitoring tested this supplier for 12 contaminants and detected 7. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

12
contaminants tested
7
detected
402
people served
0
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
SWP
Ownership
Private
Counties served
Ulster

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
5
violations on file
1
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2004-02-01 → 2004-02-29
MR Monitoring Resolved 2004-02-01 → 2004-02-29
MR Monitoring Resolved 2004-02-01 → 2004-02-29
MR Monitoring Unaddressed 1994-07-01
MR Monitoring Archived 1994-01-01 → 1994-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
4.55 µg/L
No EPA limit set
worst single sample: 4.8 µg/L
11/11 SYR4 2012–2019
Chloroform
68.7 µg/L
No EPA limit set
worst single sample: 76.5 µg/L
11/11 SYR4 2012–2019
TTHM
72.95 µg/L 91%
of the EPA limit 80 µg/L
worst single sample: 80.7 µg/L
11/11 SYR4 2012–2019
Dichloroacetic Acid
6.605 µg/L
No EPA limit set
worst single sample: 7.1 µg/L
10/11 SYR4 2012–2019
Lead
0.00060 mg/L 4%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2023
Total Haloacetic Acids (HAA5)
15.91 µg/L 27%
of the EPA limit 60 µg/L
worst single sample: 16 µg/L
10/11 SYR4 2012–2019
Trichloroacetic Acid
10.1 µg/L
No EPA limit set
worst single sample: 11 µg/L
10/11 SYR4 2012–2019
5 contaminants tested, none detected
BromoformDibromoacetic AcidDibromochloromethaneMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact
VOGT, JEFF
Phone
845-331-2201
Email
[email protected]

Frequently asked questions about Hillside Acres Water Company

Is Hillside Acres Water Company tap water safe to drink?

EPA monitoring detected 7 contaminants in Hillside Acres Water Company's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Hillside Acres Water Company's water?

EPA monitoring detected Bromodichloromethane, Chloroform, TTHM, Dichloroacetic Acid, Lead, and others. The full list with the level and data source for each is above.

How many people does Hillside Acres Water Company serve?

Hillside Acres Water Company reports serving 402 people in New York, per its EPA record.

Has Hillside Acres Water Company had any water quality violations?

The EPA has 5 violations on file for Hillside Acres Water Company, of which 0 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.