Tap WaterIndex

← New York

Tap water quality report

Hanshaw Village Mhp

EPA monitoring tested this supplier for 70 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

70
contaminants tested
12
detected
447
people served
0
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
Ground water
Ownership
Private
Counties served
Tompkins

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
14
violations on file
0
still open
ViolationTypeStatusPeriod
MON Monitoring Resolved 2023-04-01 → 2023-04-30
MON Monitoring Resolved 2023-04-01 → 2023-04-30
MON Monitoring Resolved 2023-04-01 → 2023-04-30
MON Monitoring Resolved 2023-03-01 → 2023-03-31
MON Monitoring Resolved 2023-03-01 → 2023-03-31
MON Monitoring Resolved 2023-03-01 → 2023-03-31
MON Monitoring Resolved 2022-07-01 → 2022-07-31
MON Monitoring Resolved 2022-07-01 → 2022-07-31
MON Monitoring Resolved 2022-07-01 → 2022-07-31
MR Monitoring Archived 1996-12-01 → 1996-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2025
Nitrate
676 µg/L 6.8%
of the EPA limit 10000 µg/L
 8/14 SYR4 2012–2019
Bromoform
7.214 µg/L
No EPA limit set
worst single sample: 7.3 µg/L
3/3 SYR4 2013–2019
Dibromoacetic Acid
3.063 µg/L
No EPA limit set
worst single sample: 3.07 µg/L
3/3 SYR4 2013–2019
Dibromochloromethane
1.362 µg/L
No EPA limit set
worst single sample: 1.4 µg/L
3/3 SYR4 2013–2019
Arsenic
4.965 µg/L 50%
of the EPA limit 10 µg/L
worst single sample: 5 µg/L
2/2 SYR4 2014–2017
Barium
1423.5 µg/L 71%
of the EPA limit 2000 µg/L
worst single sample: 1430 µg/L
2/2 SYR4 2014–2017
Fluoride
190.015 µg/L 4.8%
of the EPA limit 4000 µg/L
worst single sample: 200 µg/L
2/2 SYR4 2014–2017
TTHM
8.638 µg/L 11%
of the EPA limit 80 µg/L
worst single sample: 8.7 µg/L
2/2 SYR4 2013–2016
Total Haloacetic Acids (HAA5)
6.6295 µg/L 11%
of the EPA limit 60 µg/L
worst single sample: 6.9 µg/L
2/2 SYR4 2013–2016
Combined Radium (-226 And -228)
2.5 pCi/L 50%
of the EPA limit 5 pCi/L
 1/1 SYR4 2014
Monochloroacetic Acid
3.9 µg/L
No EPA limit set
 1/3 SYR4 2013–2019
58 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChloroformChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDichloroacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
INKIN, KATIE
Phone
585-802-7234
Email
[email protected]

Frequently asked questions about Hanshaw Village Mhp

Is Hanshaw Village Mhp tap water safe to drink?

EPA monitoring detected 12 contaminants in Hanshaw Village Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Hanshaw Village Mhp's water?

EPA monitoring detected Lead, Nitrate, Bromoform, Dibromoacetic Acid, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Hanshaw Village Mhp serve?

Hanshaw Village Mhp reports serving 447 people in New York, per its EPA record.

Has Hanshaw Village Mhp had any water quality violations?

The EPA has 14 violations on file for Hanshaw Village Mhp, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.