Tap WaterIndex

← New York

Tap water quality report

Dryden Village

EPA monitoring tested this supplier for 70 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

70
contaminants tested
16
detected
2,000
people served
110
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
Ground water
Ownership
Local government
Counties served
Tompkins

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

110
health-based violations
173
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2018-07-01 → 2018-09-30
MCL Health-based Resolved 2018-07-01 → 2018-09-30
MCL Health-based Resolved 2018-07-01 → 2018-09-30
MCL Health-based Resolved 2018-07-01 → 2018-09-30
MCL Health-based Resolved 2018-04-01 → 2018-06-30
MCL Health-based Resolved 2018-04-01 → 2018-06-30
MCL Health-based Resolved 2018-04-01 → 2018-06-30
MCL Health-based Resolved 2018-04-01 → 2018-06-30
MCL Health-based Resolved 2018-01-01 → 2018-03-31
MCL Health-based Resolved 2018-01-01 → 2018-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Arsenic
17.85 µg/L 179%
of the EPA limit, at the 95th percentile of samples — 10 µg/L
worst single sample: 19 µg/L
27/28 SYR4 2012–2018
Bromodichloromethane
4.58 µg/L
No EPA limit set
worst single sample: 4.7 µg/L
13/13 SYR4 2013–2019
Chloroform
7.68 µg/L
No EPA limit set
worst single sample: 7.8 µg/L
13/13 SYR4 2013–2019
Dibromochloromethane
2.8 µg/L
No EPA limit set
worst single sample: 3.1 µg/L
13/13 SYR4 2013–2019
TTHM
15.98 µg/L 20%
of the EPA limit 80 µg/L
worst single sample: 16.1 µg/L
13/13 SYR4 2013–2019
Dichloroacetic Acid
3.2035 µg/L
No EPA limit set
worst single sample: 3.44 µg/L
12/13 SYR4 2013–2019
Lead
0.0024 mg/L 16%
of the EPA limit 0.0150 mg/L
 12/12 LCR 2023
Total Haloacetic Acids (HAA5)
6.1125 µg/L 10%
of the EPA limit 60 µg/L
worst single sample: 6.25 µg/L
12/13 SYR4 2013–2019
Combined Radium (-226 And -228)
1.5755 pCi/L 32%
of the EPA limit 5 pCi/L
worst single sample: 1.68 pCi/L
11/11 SYR4 2014–2019
Dibromoacetic Acid
1.178 µg/L
No EPA limit set
worst single sample: 1.23 µg/L
9/13 SYR4 2013–2019
Trichloroacetic Acid
1.517 µg/L
No EPA limit set
worst single sample: 1.58 µg/L
8/13 SYR4 2013–2019
Barium
190 µg/L 9.5%
of the EPA limit 2000 µg/L
 5/5 SYR4 2012–2018
Bromoform
1.158 µg/L
No EPA limit set
worst single sample: 1.2 µg/L
5/13 SYR4 2013–2019
Nitrate
64.3 µg/L 0.6%
of the EPA limit 10000 µg/L
 4/54 SYR4 2012–2019
Fluoride
200 µg/L 5%
of the EPA limit 4000 µg/L
 3/5 SYR4 2012–2018
Monochloroacetic Acid
1.368 µg/L
No EPA limit set
worst single sample: 1.4 µg/L
3/13 SYR4 2013–2019
54 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
SABIN JR., PAUL
Phone
607-844-8122
Email
[email protected]

Frequently asked questions about Dryden Village

Is Dryden Village tap water safe to drink?

EPA monitoring detected 16 contaminants in Dryden Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Dryden Village's water?

EPA monitoring detected Arsenic, Bromodichloromethane, Chloroform, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does Dryden Village serve?

Dryden Village reports serving 2,000 people in New York, per its EPA record.

Has Dryden Village had any water quality violations?

The EPA has 173 violations on file for Dryden Village, of which 110 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.