← New York

Tap water quality report

Prestwick Chase Pud

EPA monitoring tested this supplier for 70 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

70
contaminants tested
13
detected
300
people served
7
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Saratoga

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

7
health-based violations
128
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2008-07-01 → 2008-07-31
MCL Health-based Resolved 2008-07-01 → 2008-07-31
MCL Health-based Resolved 2008-07-01 → 2008-07-31
MCL Health-based Resolved 2008-07-01 → 2008-07-31
MCL Health-based Resolved 2008-07-01 → 2008-07-31
MCL Health-based Resolved 2008-07-01 → 2008-07-31
MCL Health-based Resolved 2002-01-01 → 2004-12-31
MR Monitoring Resolved 2018-01-01
MR Monitoring Resolved 2018-01-01
MR Monitoring Resolved 2018-01-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
583 µg/L 5.8%
of the EPA limit 10000 µg/L
18/20 SYR4 2012–2019
Lead
0.0073 mg/L 49%
of the EPA limit 0.0150 mg/L
15/15 LCR 2027
Bromodichloromethane
6.225 µg/L
No EPA limit set
worst single sample: 6.3 µg/L
4/4 SYR4 2013–2019
Dibromochloromethane
2.488 µg/L
No EPA limit set
worst single sample: 2.5 µg/L
4/4 SYR4 2013–2019
Dichloroacetic Acid
9.795 µg/L
No EPA limit set
worst single sample: 10.5 µg/L
4/4 SYR4 2013–2019
TTHM
22.295 µg/L 28%
of the EPA limit 80 µg/L
worst single sample: 22.7 µg/L
4/4 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
17.53 µg/L 29%
of the EPA limit 60 µg/L
worst single sample: 19 µg/L
4/4 SYR4 2013–2019
Trichloroacetic Acid
7.735 µg/L
No EPA limit set
worst single sample: 8.5 µg/L
4/4 SYR4 2013–2019
Chloroform
15.26 µg/L
No EPA limit set
worst single sample: 15.7 µg/L
3/3 SYR4 2013–2019
Barium
150.85 µg/L 7.5%
of the EPA limit 2000 µg/L
worst single sample: 151 µg/L
2/2 SYR4 2014–2017
Fluoride
162.55 µg/L 4.1%
of the EPA limit 4000 µg/L
worst single sample: 163 µg/L
2/2 SYR4 2014–2017
Arsenic
0.6000 µg/L 6%
of the EPA limit 10 µg/L
1/3 SYR4 2014–2017
Combined Radium (-226 And -228)
1.09 pCi/L 22%
of the EPA limit 5 pCi/L
1/1 SYR4 2019
57 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
BARILE, BILL
Phone
518-371-7621
Email
[email protected]

Frequently asked questions about Prestwick Chase Pud

Is Prestwick Chase Pud tap water safe to drink?

EPA monitoring detected 13 contaminants in Prestwick Chase Pud's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Prestwick Chase Pud's water?

EPA monitoring detected Nitrate, Lead, Bromodichloromethane, Dibromochloromethane, Dichloroacetic Acid, and others. The full list with the level and data source for each is above.

How many people does Prestwick Chase Pud serve?

Prestwick Chase Pud reports serving 300 people in New York, per its EPA record.

Has Prestwick Chase Pud had any water quality violations?

The EPA has 128 violations on file for Prestwick Chase Pud, of which 7 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.