Tap WaterIndex

← New York

Tap water quality report

Hillburn Village

EPA monitoring tested this supplier for 12 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

12
contaminants tested
10
detected
950
people served
1
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
SWP
Ownership
Local government
Counties served
Rockland

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

1
health-based violations
4
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 1996-01-01
RPT Monitoring Resolved 2024-10-17
RPT Monitoring Resolved 2024-10-17
RPT Monitoring Resolved 2024-10-17

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
13.149 µg/L
No EPA limit set
worst single sample: 16.87 µg/L
27/28 SYR4 2012–2019
Chloroform
25.086 µg/L
No EPA limit set
worst single sample: 27.19 µg/L
25/28 SYR4 2012–2019
Dichloroacetic Acid
9.46 µg/L
No EPA limit set
worst single sample: 12.1 µg/L
25/29 SYR4 2012–2019
Dibromochloromethane
9.7385 µg/L
No EPA limit set
worst single sample: 10.28 µg/L
24/27 SYR4 2012–2019
TTHM
45.886 µg/L 57%
of the EPA limit 80 µg/L
worst single sample: 57.45 µg/L
24/25 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
14.01 µg/L 23%
of the EPA limit 60 µg/L
worst single sample: 19.7 µg/L
24/29 SYR4 2012–2019
Dibromoacetic Acid
2.9515 µg/L
No EPA limit set
worst single sample: 4.5 µg/L
20/29 SYR4 2012–2019
Trichloroacetic Acid
3.224 µg/L
No EPA limit set
worst single sample: 4.16 µg/L
19/30 SYR4 2012–2019
Bromoform
3.173 µg/L
No EPA limit set
worst single sample: 3.53 µg/L
18/28 SYR4 2012–2019
Lead
0.0034 mg/L 23%
of the EPA limit 0.0150 mg/L
 3/3 LCR 2000
2 contaminants tested, none detected
Monobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact
DEFREESE, GLADYS
Phone
845-357-2036
Email
[email protected]

Frequently asked questions about Hillburn Village

Is Hillburn Village tap water safe to drink?

EPA monitoring detected 10 contaminants in Hillburn Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Hillburn Village's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dichloroacetic Acid, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does Hillburn Village serve?

Hillburn Village reports serving 950 people in New York, per its EPA record.

Has Hillburn Village had any water quality violations?

The EPA has 4 violations on file for Hillburn Village, of which 1 is health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.