Tap WaterIndex

← New York

Tap water quality report

Carlton Water District

EPA monitoring tested this supplier for 12 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

12
contaminants tested
12
detected
2,800
people served
0
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
SWP
Ownership
Local government
Counties served
Orleans

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
2
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2011-12-01 → 2011-12-31
Other Monitoring Resolved 2011-12-01 → 2011-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
14.4 µg/L
No EPA limit set
worst single sample: 15 µg/L
13/13 SYR4 2013–2019
Chloroform
23.4 µg/L
No EPA limit set
worst single sample: 24 µg/L
13/13 SYR4 2013–2019
Dibromochloromethane
8.5 µg/L
No EPA limit set
worst single sample: 8.8 µg/L
13/13 SYR4 2013–2019
Dichloroacetic Acid
22.4 µg/L
No EPA limit set
worst single sample: 26 µg/L
13/13 SYR4 2013–2019
TTHM
45.8 µg/L 57%
of the EPA limit 80 µg/L
worst single sample: 47 µg/L
13/13 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
41.8 µg/L 70%
of the EPA limit 60 µg/L
worst single sample: 46 µg/L
13/13 SYR4 2013–2019
Trichloroacetic Acid
15.2 µg/L
No EPA limit set
worst single sample: 20 µg/L
13/13 SYR4 2013–2019
Dibromoacetic Acid
3.715 µg/L
No EPA limit set
worst single sample: 4.1 µg/L
12/13 SYR4 2013–2019
Bromoform
2.7 µg/L
No EPA limit set
worst single sample: 3.1 µg/L
11/13 SYR4 2013–2019
Monochloroacetic Acid
5.35 µg/L
No EPA limit set
worst single sample: 5.9 µg/L
6/13 SYR4 2013–2019
Monobromoacetic Acid
4.54 µg/L
No EPA limit set
worst single sample: 4.8 µg/L
5/13 SYR4 2013–2019
Lead
0.0110 mg/L 73%
of the EPA limit 0.0150 mg/L
 3/3 LCR 2005

Utility contact

Contact
ASHBERY, GAYLE
Phone
585-682-4358

Frequently asked questions about Carlton Water District

Is Carlton Water District tap water safe to drink?

EPA monitoring detected 12 contaminants in Carlton Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Carlton Water District's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, Dichloroacetic Acid, TTHM, and others. The full list with the level and data source for each is above.

How many people does Carlton Water District serve?

Carlton Water District reports serving 2,800 people in New York, per its EPA record.

Has Carlton Water District had any water quality violations?

The EPA has 2 violations on file for Carlton Water District, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.