Tap WaterIndex

← New York

Tap water quality report

Wilson Village

EPA monitoring tested this supplier for 12 contaminants and detected 11. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

12
contaminants tested
11
detected
1,213
people served
0
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
SWP
Ownership
Local government
Counties served
Niagara

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
3
violations on file
1
still open
ViolationTypeStatusPeriod
MR Monitoring Unaddressed 2026-01-01
MR Monitoring Archived 2025-01-01 → 2025-03-31
MR Monitoring Archived 2025-01-01 → 2025-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
14.9975 µg/L
No EPA limit set
worst single sample: 18.79 µg/L
26/26 SYR4 2013–2019
Chloroform
39.17 µg/L
No EPA limit set
worst single sample: 49.35 µg/L
26/26 SYR4 2013–2019
Dibromochloromethane
5.9075 µg/L
No EPA limit set
worst single sample: 6.81 µg/L
26/26 SYR4 2013–2019
TTHM
60.075 µg/L 75%
of the EPA limit 80 µg/L
worst single sample: 74.95 µg/L
26/26 SYR4 2013–2019
Dichloroacetic Acid
22.306 µg/L
No EPA limit set
worst single sample: 23.42 µg/L
25/25 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
33.302 µg/L 56%
of the EPA limit 60 µg/L
worst single sample: 36.02 µg/L
25/25 SYR4 2013–2019
Trichloroacetic Acid
11.44 µg/L
No EPA limit set
worst single sample: 19.5 µg/L
25/25 SYR4 2013–2019
Lead
0.0060 mg/L 40%
of the EPA limit 0.0150 mg/L
 11/11 LCR 2023
Bromoform
1.473 µg/L
No EPA limit set
worst single sample: 1.48 µg/L
8/26 SYR4 2013–2019
Monochloroacetic Acid
9.379 µg/L
No EPA limit set
worst single sample: 10.8 µg/L
8/25 SYR4 2013–2019
Dibromoacetic Acid
1.935 µg/L
No EPA limit set
worst single sample: 1.95 µg/L
7/25 SYR4 2013–2019
1 contaminants tested, none detected
Monobromoacetic Acid

Utility contact

Contact
LAWSON, ARTHUR
Phone
716-751-6764
Email
[email protected]

Frequently asked questions about Wilson Village

Is Wilson Village tap water safe to drink?

EPA monitoring detected 11 contaminants in Wilson Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Wilson Village's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, TTHM, Dichloroacetic Acid, and others. The full list with the level and data source for each is above.

How many people does Wilson Village serve?

Wilson Village reports serving 1,213 people in New York, per its EPA record.

Has Wilson Village had any water quality violations?

The EPA has 3 violations on file for Wilson Village, of which 0 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.