← New York

Tap water quality report

Tannersville Village

EPA monitoring tested this supplier for 74 contaminants and detected 17. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

74
contaminants tested
17
detected
629
people served
13
health-based violations
Water source
Surface water
Ownership
Local government
Counties served
Greene

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

13
health-based violations
81
violations on file
6
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2011-10-01 → 2012-09-30
MCL Health-based Resolved 2011-10-01 → 2012-09-30
MCL Health-based Resolved 2011-10-01 → 2012-09-30
MCL Health-based Resolved 2007-07-01 → 2007-09-30
MCL Health-based Resolved 2007-07-01 → 2007-09-30
MCL Health-based Resolved 2007-04-01 → 2007-06-30
MCL Health-based Resolved 2007-04-01 → 2007-06-30
TT Health-based Resolved 2006-08-01 → 2006-08-31
TT Health-based Resolved 2006-08-01 → 2006-08-31
TT Health-based Resolved 2006-08-01 → 2006-08-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
467 µg/L 4.7%
of the EPA limit 10000 µg/L
worst single sample: 470 µg/L
24/34 SYR4 2012–2019
Lead
0.0011 mg/L 7.3%
of the EPA limit 0.0150 mg/L
17/17 LCR 2024
Arsenic
27.84 µg/L 278%
of the EPA limit, at the 95th percentile of samples — 10 µg/L
worst single sample: 29.8 µg/L
15/24 SYR4 2012–2019
TTHM
45.96 µg/L 57%
of the EPA limit 80 µg/L
worst single sample: 53.4 µg/L
13/13 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
44.52 µg/L 74%
of the EPA limit 60 µg/L
worst single sample: 48.3 µg/L
13/13 SYR4 2012–2019
Barium
16 µg/L 0.8%
of the EPA limit 2000 µg/L
worst single sample: 17 µg/L
11/12 SYR4 2012–2019
Bromodichloromethane
1.92 µg/L
No EPA limit set
worst single sample: 2 µg/L
3/3 SYR4 2012–2014
Chloroform
19.8 µg/L
No EPA limit set
worst single sample: 20 µg/L
3/3 SYR4 2012–2014
Dichloroacetic Acid
10.64 µg/L
No EPA limit set
worst single sample: 11 µg/L
3/3 SYR4 2012–2014
Fluoride
526 µg/L 13%
of the EPA limit 4000 µg/L
worst single sample: 550 µg/L
3/12 SYR4 2012–2019
Trichloroacetic Acid
9.48 µg/L
No EPA limit set
worst single sample: 9.5 µg/L
2/3 SYR4 2012–2014
Antimony, Total
1.5 µg/L 25%
of the EPA limit 6 µg/L
1/12 SYR4 2012–2019
Combined Radium (-226 And -228)
0.4300 pCi/L 8.6%
of the EPA limit 5 pCi/L
1/3 SYR4 2014–2019
Dichloromethane
0.7000 µg/L 14%
of the EPA limit 5 µg/L
1/12 SYR4 2012–2019
Di(2-ethylhexyl) Phthalate
0.7900 µg/L 13%
of the EPA limit 6 µg/L
1/4 SYR4 2012–2019
Ethylbenzene
0.7000 µg/L 0.1%
of the EPA limit 700 µg/L
1/12 SYR4 2012–2019
Nitrate-Nitrite
350 µg/L 3.5%
of the EPA limit 10000 µg/L
1/1 SYR4 2014
57 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDalaponDi(2-ethylhexyl) AdipateDibromoacetic AcidDibromochloromethaneDinosebEthylene DibromideEndrinGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
TANNERSVILLE MAYOR VILLAGE BOARD
Phone
518-589-5850
Email
[email protected]

Frequently asked questions about Tannersville Village

Is Tannersville Village tap water safe to drink?

EPA monitoring detected 17 contaminants in Tannersville Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Tannersville Village's water?

EPA monitoring detected Nitrate, Lead, Arsenic, TTHM, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Tannersville Village serve?

Tannersville Village reports serving 629 people in New York, per its EPA record.

Has Tannersville Village had any water quality violations?

The EPA has 81 violations on file for Tannersville Village, of which 13 are health-based (a contaminant limit or required treatment was breached) and 6 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.