← New York

Tap water quality report

Kenmore Village

EPA monitoring tested this supplier for 42 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

42
contaminants tested
12
detected
15,423
people served
0
health-based violations
Water source
SWP
Ownership
Local government
Counties served
Erie

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
9
violations on file
2
still open
ViolationTypeStatusPeriod
Other Monitoring Unaddressed 2020-12-31
Other Monitoring Unaddressed 2020-12-31
MR Monitoring Resolved 2007-09-01 → 2007-09-30
MR Monitoring Resolved 2007-09-01 → 2007-09-30
MR Monitoring Resolved 2007-09-01 → 2007-09-30
MR Monitoring Resolved 2007-08-01 → 2007-08-31
MR Monitoring Resolved 2007-08-01 → 2007-08-31
MR Monitoring Resolved 2007-08-01 → 2007-08-31
Other Monitoring Resolved 2000-07-01 → 2001-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
13 µg/L
No EPA limit set
worst single sample: 14.2 µg/L
72/72 SYR4 2012–2019
Chloroform
25.395 µg/L
No EPA limit set
worst single sample: 37.2 µg/L
72/72 SYR4 2012–2019
Dibromochloromethane
6.759 µg/L
No EPA limit set
worst single sample: 12 µg/L
72/72 SYR4 2012–2019
TTHM
45.69 µg/L 57%
of the EPA limit 80 µg/L
worst single sample: 57.5 µg/L
72/72 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
19.378 µg/L 32%
of the EPA limit 60 µg/L
worst single sample: 69.2 µg/L
68/72 SYR4 2012–2019
Trichloroacetic Acid
9.08 µg/L
No EPA limit set
worst single sample: 11.6 µg/L
61/72 SYR4 2012–2019
Dichloroacetic Acid
12.725 µg/L
No EPA limit set
worst single sample: 60.9 µg/L
58/72 SYR4 2012–2019
Dibromoacetic Acid
2.266 µg/L
No EPA limit set
worst single sample: 2.44 µg/L
37/72 SYR4 2012–2019
Monochloroacetic Acid
3.753 µg/L
No EPA limit set
worst single sample: 4.61 µg/L
35/72 SYR4 2012–2019
Monobromoacetic Acid
3.196 µg/L
No EPA limit set
worst single sample: 3.34 µg/L
13/72 SYR4 2012–2019
Bromoform
8.191 µg/L
No EPA limit set
worst single sample: 17.2 µg/L
12/72 SYR4 2012–2019
Lead
0.0021 mg/L 14%
of the EPA limit 0.0150 mg/L
11/11 LCR 2024
30 contaminants tested, none detected
11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaHfpo-DaNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaLithium

Utility contact

Contact
JOHNSON, KATHLEEN P.
Phone
716-873-5700
Email
[email protected]

Frequently asked questions about Kenmore Village

Is Kenmore Village tap water safe to drink?

EPA monitoring detected 12 contaminants in Kenmore Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Kenmore Village's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, TTHM, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Kenmore Village serve?

Kenmore Village reports serving 15,423 people in New York, per its EPA record.

Has Kenmore Village had any water quality violations?

The EPA has 9 violations on file for Kenmore Village, of which 0 are health-based (a contaminant limit or required treatment was breached) and 2 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.