← New Jersey

Tap water quality report

Forest Lakes Water

EPA monitoring tested this supplier for 53 contaminants and detected 23. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

53
contaminants tested
23
detected
1,410
people served
4
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Sussex

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
29
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MR Monitoring Archived 2025-04-01 → 2025-06-30
MR Monitoring Archived 2025-04-01 → 2025-06-30
MR Monitoring Resolved 2023-01-01 → 2023-03-31
MR Monitoring Resolved 2023-01-01 → 2023-03-31
MR Monitoring Resolved 2023-01-01 → 2023-03-31
MR Monitoring Resolved 2019-10-01 → 2019-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
159.5 µg/L 12%
of the EPA limit 1300 µg/L
worst single sample: 200 µg/L
31/33 SYR4 2012–2018
Lead
5.88 µg/L 39%
of the EPA limit 15 µg/L
worst single sample: 7.2 µg/L
25/30 SYR4 2012–2018
Chloroform
3.756 µg/L
No EPA limit set
worst single sample: 6.06 µg/L
17/19 SYR4 2012–2019
Bromodichloromethane
3.925 µg/L
No EPA limit set
worst single sample: 4.6 µg/L
16/19 SYR4 2012–2019
Dibromochloromethane
3.2725 µg/L
No EPA limit set
worst single sample: 3.34 µg/L
16/19 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
16/16 LCR 2024
TTHM
11.675 µg/L 15%
of the EPA limit 80 µg/L
worst single sample: 14 µg/L
16/16 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
5.1635 µg/L 8.6%
of the EPA limit 60 µg/L
worst single sample: 5.3 µg/L
14/16 SYR4 2012–2019
Dichloroacetic Acid
2.343 µg/L
No EPA limit set
worst single sample: 2.75 µg/L
12/16 SYR4 2012–2019
Bromoform
1.255 µg/L
No EPA limit set
worst single sample: 1.31 µg/L
11/19 SYR4 2012–2019
Dibromoacetic Acid
2.03 µg/L
No EPA limit set
worst single sample: 2.34 µg/L
11/16 SYR4 2012–2019
Nitrate
854 µg/L 8.5%
of the EPA limit 10000 µg/L
10/12 SYR4 2013–2019
Barium
119.65 µg/L 6%
of the EPA limit 2000 µg/L
worst single sample: 130 µg/L
3/3 SYR4 2012–2018
Trichloroacetic Acid
1.11 µg/L
No EPA limit set
worst single sample: 1.19 µg/L
3/16 SYR4 2012–2019
Arsenic
0.2865 µg/L 2.9%
of the EPA limit 10 µg/L
worst single sample: 0.2900 µg/L
2/3 SYR4 2012–2018
Fluoride
131.415 µg/L 3.3%
of the EPA limit 4000 µg/L
worst single sample: 135 µg/L
2/5 SYR4 2012–2018
Monobromoacetic Acid
1.914 µg/L
No EPA limit set
worst single sample: 1.92 µg/L
2/16 SYR4 2012–2019
Selenium
0.3200 µg/L 0.6%
of the EPA limit 50 µg/L
worst single sample: 0.3300 µg/L
2/3 SYR4 2012–2018
Antimony, Total
0.0600 µg/L 1%
of the EPA limit 6 µg/L
1/3 SYR4 2012–2018
Chromium
1.8 µg/L 1.8%
of the EPA limit 100 µg/L
1/3 SYR4 2012–2018
Combined Radium (-226 And -228)
0.6700 pCi/L 13%
of the EPA limit 5 pCi/L
1/2 SYR4 2012–2018
Mercury
0.1230 µg/L 6.2%
of the EPA limit 2 µg/L
1/3 SYR4 2012–2018
Nitrate-Nitrite
757 µg/L 7.6%
of the EPA limit 10000 µg/L
1/1 SYR4 2017
30 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAsbestosBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideCombined UraniumDichloromethaneEthylene DibromideEthylbenzeneMonochloroacetic AcidStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
GORMAN, DOROTHY
Phone
973-534-3757

Frequently asked questions about Forest Lakes Water

Is Forest Lakes Water tap water safe to drink?

EPA monitoring detected 23 contaminants in Forest Lakes Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Forest Lakes Water's water?

EPA monitoring detected Copper, Lead, Chloroform, Bromodichloromethane, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Forest Lakes Water serve?

Forest Lakes Water reports serving 1,410 people in New Jersey, per its EPA record.

Has Forest Lakes Water had any water quality violations?

The EPA has 29 violations on file for Forest Lakes Water, of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.