← New Jersey

Tap water quality report

Hightstown Water Department

EPA monitoring tested this supplier for 80 contaminants and detected 21. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

80
contaminants tested
21
detected
5,400
people served
4
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Mercer

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
126
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2012-07-01 → 2012-07-31
MCL Health-based Resolved 2012-07-01 → 2012-07-31
MCL Health-based Resolved 2012-07-01 → 2012-07-31
MCL Health-based Resolved 2012-07-01 → 2012-07-31
Other Monitoring Resolved 2021-07-01
Other Monitoring Resolved 2021-07-01
Other Monitoring Resolved 2015-07-01
Other Monitoring Resolved 2015-07-01
MR Monitoring Resolved 2015-01-01 → 2015-12-31
MR Monitoring Resolved 2015-01-01 → 2015-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
30.6 µg/L 2.4%
of the EPA limit 1300 µg/L
worst single sample: 64.9 µg/L
51/53 SYR4 2014–2018
Dibromochloromethane
2.604 µg/L
No EPA limit set
worst single sample: 3.2 µg/L
45/46 SYR4 2012–2019
Bromodichloromethane
1.9835 µg/L
No EPA limit set
worst single sample: 2.6 µg/L
44/46 SYR4 2012–2019
Chloroform
2.687 µg/L
No EPA limit set
worst single sample: 3.1 µg/L
43/46 SYR4 2012–2019
Lead
4.315 µg/L 29%
of the EPA limit 15 µg/L
worst single sample: 48.3 µg/L
42/47 SYR4 2014–2017
Bromoform
1.966 µg/L
No EPA limit set
worst single sample: 2.08 µg/L
38/46 SYR4 2012–2019
Lead
0.0017 mg/L 11%
of the EPA limit 0.0150 mg/L
16/16 LCR 2023
TTHM
9.15 µg/L 11%
of the EPA limit 80 µg/L
worst single sample: 9.5 µg/L
15/16 SYR4 2012–2019
Xylenes, Total
1.96 µg/L 0%
of the EPA limit 10000 µg/L
worst single sample: 2.5 µg/L
10/30 SYR4 2012–2019
Fluoride
1275 µg/L 32%
of the EPA limit 4000 µg/L
worst single sample: 1300 µg/L
6/6 SYR4 2014–2018
Barium
30.3 µg/L 1.5%
of the EPA limit 2000 µg/L
3/3 SYR4 2014–2018
Ethylbenzene
0.2900 µg/L 0%
of the EPA limit 700 µg/L
worst single sample: 0.3000 µg/L
3/30 SYR4 2012–2019
Arsenic
0.4700 µg/L 4.7%
of the EPA limit 10 µg/L
2/3 SYR4 2014–2018
Combined Radium (-226 And -228)
1.5 pCi/L 30%
of the EPA limit 5 pCi/L
2/2 SYR4 2012–2018
Dibromoacetic Acid
1.2655 µg/L
No EPA limit set
worst single sample: 1.27 µg/L
2/15 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
2.4385 µg/L 4.1%
of the EPA limit 60 µg/L
worst single sample: 2.5 µg/L
2/15 SYR4 2012–2019
Lithium
24 µg/L
No EPA limit set
2/2 UCMR-5 2025
Dichloroacetic Acid
0.7900 µg/L
No EPA limit set
1/15 SYR4 2012–2019
Mercury
0.0640 µg/L 3.2%
of the EPA limit 2 µg/L
1/3 SYR4 2014–2018
Selenium
0.8900 µg/L 1.8%
of the EPA limit 50 µg/L
1/3 SYR4 2014–2018
Trichloroacetic Acid
0.5300 µg/L
No EPA limit set
1/15 SYR4 2012–2019
59 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneEthylene DibromideHfpo-DaMonobromoacetic AcidMonochloroacetic AcidNetfosaaNfdhaNmefosaaNitratePfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
LEWIS, RICHARD
Phone
609-490-5117

Frequently asked questions about Hightstown Water Department

Is Hightstown Water Department tap water safe to drink?

EPA monitoring detected 21 contaminants in Hightstown Water Department's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Hightstown Water Department's water?

EPA monitoring detected Copper, Dibromochloromethane, Bromodichloromethane, Chloroform, Lead, and others. The full list with the level and data source for each is above.

How many people does Hightstown Water Department serve?

Hightstown Water Department reports serving 5,400 people in New Jersey, per its EPA record.

Has Hightstown Water Department had any water quality violations?

The EPA has 126 violations on file for Hightstown Water Department, of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.