Tap WaterIndex

← New Hampshire

Tap water quality report

Daniels Lake

EPA monitoring tested this supplier for 77 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

77
contaminants tested
13
detected
78
people served
18
health-based violations
New Hampshire rankingsLead in New HampshirePFAS in New Hampshire
Water source
Ground water
Ownership
Private
Counties served
Hillsborough

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

18
health-based violations
305
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2007-11-01 → 2007-11-30
MCL Health-based Resolved 2007-11-01 → 2007-11-30
MCL Health-based Resolved 2007-11-01 → 2007-11-30
MCL Health-based Resolved 2007-11-01 → 2007-11-30
TT Health-based Resolved 2007-10-01
TT Health-based Resolved 2007-10-01
MCL Health-based Resolved 2005-06-01 → 2005-06-30
MCL Health-based Resolved 2005-06-01 → 2005-06-30
MCL Health-based Resolved 2005-06-01 → 2005-06-30
MCL Health-based Resolved 2005-06-01 → 2005-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
157.2 µg/L 12%
of the EPA limit 1300 µg/L
worst single sample: 165 µg/L
14/14 SYR4 2015–2019
Bromodichloromethane
4.055 µg/L
No EPA limit set
worst single sample: 4.3 µg/L
8/8 SYR4 2014–2019
Chloroform
7.435 µg/L
No EPA limit set
worst single sample: 8.1 µg/L
8/8 SYR4 2014–2019
Dibromochloromethane
1.565 µg/L
No EPA limit set
worst single sample: 1.6 µg/L
8/8 SYR4 2014–2019
TTHM
12.95 µg/L 16%
of the EPA limit 80 µg/L
worst single sample: 14 µg/L
8/8 SYR4 2014–2019
Lead
0.0300 mg/L 200%
above the EPA limit of 0.0150 mg/L
 3/3 LCR 2002
Barium
8.58805 µg/L 0.4%
of the EPA limit 2000 µg/L
worst single sample: 8.6 µg/L
2/2 SYR4 2016–2019
Dichloroacetic Acid
2.57825 µg/L
No EPA limit set
worst single sample: 2.635 µg/L
2/2 SYR4 2014–2017
Total Haloacetic Acids (HAA5)
4.16 µg/L 6.9%
of the EPA limit 60 µg/L
worst single sample: 4.3 µg/L
2/2 SYR4 2014–2017
Combined Radium (-226 And -228)
0.2000 pCi/L 4%
of the EPA limit 5 pCi/L
 1/1 SYR4 2015
Di(2-ethylhexyl) Phthalate
1.99 µg/L 33%
of the EPA limit 6 µg/L
 1/17 SYR4 2014–2019
Gross Alpha, Excl. Radon And U
0.2000 pCi/L 1.3%
of the EPA limit 15 pCi/L
 1/1 SYR4 2015
Trichloroacetic Acid
1.679 µg/L
No EPA limit set
 1/2 SYR4 2014–2017
64 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDibromoacetic AcidDinosebDiquatEthylene DibromideEndrinEthylbenzeneFluorideGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitrateNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
LESLIE MORGAN

Frequently asked questions about Daniels Lake

Is Daniels Lake tap water safe to drink?

EPA monitoring detected 13 contaminants in Daniels Lake's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Daniels Lake's water?

EPA monitoring detected Copper, Bromodichloromethane, Chloroform, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does Daniels Lake serve?

Daniels Lake reports serving 78 people in New Hampshire, per its EPA record.

Has Daniels Lake had any water quality violations?

The EPA has 305 violations on file for Daniels Lake, of which 18 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.