← North Dakota

Tap water quality report

Kenmare City of

EPA monitoring tested this supplier for 14 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
12
detected
961
people served
24
health-based violations
Water source
GWP
Ownership
Local government
Counties served
Ward

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

24
health-based violations
47
violations on file
2
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2009-10-01 → 2009-12-31
MCL Health-based Archived 2009-10-01 → 2009-12-31
MCL Health-based Archived 2009-10-01 → 2009-12-31
MCL Health-based Archived 2009-10-01 → 2009-12-31
MCL Health-based Archived 2009-07-01 → 2009-09-30
MCL Health-based Archived 2009-07-01 → 2009-09-30
MCL Health-based Archived 2009-07-01 → 2009-09-30
MCL Health-based Archived 2009-07-01 → 2009-09-30
MCL Health-based Archived 2009-04-01 → 2009-06-30
MCL Health-based Archived 2009-04-01 → 2009-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
189.05 µg/L 15%
of the EPA limit 1300 µg/L
worst single sample: 362 µg/L
28/40 SYR4 2012–2019
Lead
0.0038 mg/L 25%
of the EPA limit 0.0150 mg/L
27/27 LCR 2025
Lead
8.474 µg/L 56%
of the EPA limit 15 µg/L
worst single sample: 9.32 µg/L
13/40 SYR4 2012–2019
Bromodichloromethane
8.928 µg/L
No EPA limit set
worst single sample: 8.95 µg/L
12/12 SYR4 2014–2019
Bromoform
19.644 µg/L
No EPA limit set
worst single sample: 19.71 µg/L
12/12 SYR4 2014–2019
Chloroform
4.138 µg/L
No EPA limit set
worst single sample: 4.16 µg/L
12/12 SYR4 2014–2019
Dibromoacetic Acid
9.795 µg/L
No EPA limit set
worst single sample: 10.4 µg/L
12/12 SYR4 2014–2019
Dibromochloromethane
14.788 µg/L
No EPA limit set
worst single sample: 15.03 µg/L
12/12 SYR4 2014–2019
Dichloroacetic Acid
6.0215 µg/L
No EPA limit set
worst single sample: 6.06 µg/L
12/12 SYR4 2014–2019
TTHM
45.5415 µg/L 57%
of the EPA limit 80 µg/L
worst single sample: 46.02 µg/L
12/12 SYR4 2014–2019
Total Haloacetic Acids (HAA5)
14.3045 µg/L 24%
of the EPA limit 60 µg/L
worst single sample: 14.86 µg/L
12/12 SYR4 2014–2019
Monobromoacetic Acid
1.02 µg/L
No EPA limit set
1/12 SYR4 2014–2019
2 contaminants tested, none detected
Monochloroacetic AcidTrichloroacetic Acid

Utility contact

Contact
KNUTSON, TAMMY
Phone
701-385-4232
Email
[email protected]

Frequently asked questions about Kenmare City of

Is Kenmare City of tap water safe to drink?

EPA monitoring detected 12 contaminants in Kenmare City of's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Kenmare City of's water?

EPA monitoring detected Copper, Lead, Lead, Bromodichloromethane, Bromoform, and others. The full list with the level and data source for each is above.

How many people does Kenmare City of serve?

Kenmare City of reports serving 961 people in North Dakota, per its EPA record.

Has Kenmare City of had any water quality violations?

The EPA has 47 violations on file for Kenmare City of, of which 24 are health-based (a contaminant limit or required treatment was breached) and 2 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.