Tap WaterIndex

← North Carolina

Tap water quality report

Ransdell Mhp

EPA monitoring tested this supplier for 77 contaminants and detected 11. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

77
contaminants tested
11
detected
114
people served
0
health-based violations
North Carolina rankingsLead in North CarolinaPFAS in North Carolina
Water source
Ground water
Ownership
Private
Counties served
Franklin

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
151
violations on file
0
still open
ViolationTypeStatusPeriod
RPT Monitoring Resolved 2024-06-11
RPT Monitoring Resolved 2024-06-11
RPT Monitoring Resolved 2024-06-11
RPT Monitoring Resolved 2024-06-11
RPT Monitoring Resolved 2024-06-11
RPT Monitoring Resolved 2024-06-11
MR Monitoring Resolved 2024-04-01 → 2024-06-30
MR Monitoring Resolved 2024-04-01 → 2024-06-30
MR Monitoring Resolved 2024-04-01 → 2024-06-30
MR Monitoring Resolved 2024-04-01 → 2024-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
5150 µg/L 52%
of the EPA limit 10000 µg/L
worst single sample: 5170 µg/L
26/26 SYR4 2012–2019
Lead
0.0060 mg/L 40%
of the EPA limit 0.0150 mg/L
 3/3 LCR 2025
Lead
5.7 µg/L 38%
of the EPA limit 15 µg/L
worst single sample: 6 µg/L
3/10 SYR4 2014–2017
Xylenes, Total
0.5000 µg/L 0%
of the EPA limit 10000 µg/L
 3/10 SYR4 2013–2017
Barium
83 µg/L 4.2%
of the EPA limit 2000 µg/L
 1/3 SYR4 2013–2019
Copper
69 µg/L 5.3%
of the EPA limit 1300 µg/L
 1/10 SYR4 2014–2017
Combined Radium (-226 And -228)
2.5 pCi/L 50%
of the EPA limit 5 pCi/L
 1/1 SYR4 2016
Combined Uranium
2.5628 µg/L 8.5%
of the EPA limit 30 µg/L
 1/2 SYR4 2013–2016
Fluoride
81 µg/L 2%
of the EPA limit 4000 µg/L
 1/3 SYR4 2013–2019
Mercury
2.2 µg/L 110%
of the EPA limit, at the 95th percentile of samples — 2 µg/L
 1/8 SYR4 2013–2019
Nitrate-Nitrite
4500 µg/L 45%
of the EPA limit 10000 µg/L
 1/1 SYR4 2013
66 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChloroformChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDibromochloromethaneDichloroacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTTHMTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Total Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
DEAN, PATRICIA
Phone
252-207-4947
Email
[email protected]

Frequently asked questions about Ransdell Mhp

Is Ransdell Mhp tap water safe to drink?

EPA monitoring detected 11 contaminants in Ransdell Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Ransdell Mhp's water?

EPA monitoring detected Nitrate, Lead, Lead, Xylenes, Total, Barium, and others. The full list with the level and data source for each is above.

How many people does Ransdell Mhp serve?

Ransdell Mhp reports serving 114 people in North Carolina, per its EPA record.

Has Ransdell Mhp had any water quality violations?

The EPA has 151 violations on file for Ransdell Mhp, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.