← Montana

Tap water quality report

Power Teton County Water Dist

EPA monitoring tested this supplier for 63 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

63
contaminants tested
16
detected
205
people served
0
health-based violations
Water source
Surface water
Ownership
Local government
Counties served
Teton

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
126
violations on file
0
still open
ViolationTypeStatusPeriod
MON Monitoring Resolved 2019-02-01 → 2019-02-28
MON Monitoring Resolved 2019-02-01 → 2019-02-28
MON Monitoring Resolved 2019-02-01 → 2019-02-28
MR Monitoring Resolved 2004-10-01 → 2004-12-31
MR Monitoring Resolved 2004-10-01 → 2004-12-31
MR Monitoring Resolved 2004-10-01 → 2004-12-31
MR Monitoring Resolved 2004-10-01 → 2004-12-31
MR Monitoring Resolved 2004-10-01 → 2004-12-31
MR Monitoring Resolved 2004-10-01 → 2004-12-31
MR Monitoring Resolved 2004-10-01 → 2004-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
22.25 µg/L
No EPA limit set
worst single sample: 23 µg/L
16/16 SYR4 2012–2019
Chloroform
41 µg/L
No EPA limit set
worst single sample: 47 µg/L
16/16 SYR4 2012–2019
Nitrate-Nitrite
3940 µg/L 39%
of the EPA limit 10000 µg/L
16/16 SYR4 2012–2019
Dibromochloromethane
7.52 µg/L
No EPA limit set
worst single sample: 9.2 µg/L
15/16 SYR4 2012–2019
TTHM
57.3 µg/L 72%
of the EPA limit 80 µg/L
worst single sample: 72 µg/L
15/15 SYR4 2012–2019
Lead
0.0050 mg/L 33%
of the EPA limit 0.0150 mg/L
11/11 LCR 2026
Copper
185.75 µg/L 14%
of the EPA limit 1300 µg/L
worst single sample: 188 µg/L
10/10 SYR4 2014–2017
Dichloroacetic Acid
19.3 µg/L
No EPA limit set
worst single sample: 20 µg/L
8/8 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
35.15 µg/L 59%
of the EPA limit 60 µg/L
worst single sample: 39 µg/L
8/8 SYR4 2012–2019
Trichloroacetic Acid
13.9 µg/L
No EPA limit set
worst single sample: 16 µg/L
8/8 SYR4 2012–2019
Xylenes, Total
0.9150 µg/L 0%
of the EPA limit 10000 µg/L
worst single sample: 0.9600 µg/L
6/8 SYR4 2012–2019
Monochloroacetic Acid
1.78 µg/L
No EPA limit set
worst single sample: 1.8 µg/L
5/8 SYR4 2012–2019
Dibromoacetic Acid
0.8280 µg/L
No EPA limit set
worst single sample: 0.8700 µg/L
4/8 SYR4 2012–2019
Lead
2.85 µg/L 19%
of the EPA limit 15 µg/L
worst single sample: 3 µg/L
4/10 SYR4 2014–2017
Combined Uranium
11 µg/L 37%
of the EPA limit 30 µg/L
1/1 SYR4 2012
Gross Alpha, Excl. Radon And U
2.4 pCi/L 16%
of the EPA limit 15 pCi/L
1/1 SYR4 2012
47 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBromoformChlorobenzeneCarbofuranCarbon TetrachlorideChlordaneCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMethoxychlorMonobromoacetic AcidOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneTolueneToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WALKER, KAROL A
Phone
406-463-2351
Email
[email protected]

Frequently asked questions about Power Teton County Water Dist

Is Power Teton County Water Dist tap water safe to drink?

EPA monitoring detected 16 contaminants in Power Teton County Water Dist's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Power Teton County Water Dist's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Nitrate-Nitrite, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does Power Teton County Water Dist serve?

Power Teton County Water Dist reports serving 205 people in Montana, per its EPA record.

Has Power Teton County Water Dist had any water quality violations?

The EPA has 126 violations on file for Power Teton County Water Dist, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.