← Montana

Tap water quality report

Columbus Town of

EPA monitoring tested this supplier for 72 contaminants and detected 20. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

72
contaminants tested
20
detected
1,900
people served
0
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Stillwater

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
186
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2018-07-01
Other Monitoring Resolved 2018-07-01
MON Monitoring Resolved 2018-07-01 → 2018-07-31
MON Monitoring Resolved 2018-07-01 → 2018-07-31
MON Monitoring Resolved 2018-07-01 → 2018-07-31
MON Monitoring Resolved 2018-07-01 → 2018-07-31
MR Monitoring Resolved 2015-01-01 → 2015-12-31
MR Monitoring Resolved 2015-01-01 → 2015-12-31
MR Monitoring Resolved 2015-01-01 → 2015-12-31
MR Monitoring Resolved 2015-01-01 → 2015-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate-Nitrite
3530 µg/L 35%
of the EPA limit 10000 µg/L
worst single sample: 4340 µg/L
48/48 SYR4 2012–2019
Copper
427.1 µg/L 33%
of the EPA limit 1300 µg/L
worst single sample: 467 µg/L
20/20 SYR4 2014–2017
Lead
6.4 µg/L 43%
of the EPA limit 15 µg/L
worst single sample: 9 µg/L
14/20 SYR4 2014–2017
Arsenic
8.45 µg/L 85%
of the EPA limit 10 µg/L
worst single sample: 9 µg/L
12/15 SYR4 2013–2019
Lead
0.0040 mg/L 27%
of the EPA limit 0.0150 mg/L
12/12 LCR 2017
Dibromochloromethane
7.3 µg/L
No EPA limit set
worst single sample: 7.4 µg/L
11/20 SYR4 2013–2019
TTHM
17 µg/L 21%
of the EPA limit 80 µg/L
11/20 SYR4 2013–2019
Bromoform
5.785 µg/L
No EPA limit set
worst single sample: 6.1 µg/L
10/20 SYR4 2013–2019
Fluoride
500 µg/L 13%
of the EPA limit 4000 µg/L
9/9 SYR4 2013–2019
Selenium
5.6 µg/L 11%
of the EPA limit 50 µg/L
worst single sample: 6 µg/L
9/9 SYR4 2013–2019
Bromodichloromethane
3.35 µg/L
No EPA limit set
worst single sample: 3.5 µg/L
7/20 SYR4 2013–2019
Barium
90 µg/L 4.5%
of the EPA limit 2000 µg/L
6/9 SYR4 2013–2019
Dibromoacetic Acid
2.825 µg/L
No EPA limit set
worst single sample: 3 µg/L
6/8 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
5.15 µg/L 8.6%
of the EPA limit 60 µg/L
worst single sample: 5.7 µg/L
6/8 SYR4 2013–2019
Chloroform
3.72 µg/L
No EPA limit set
worst single sample: 4.1 µg/L
5/20 SYR4 2013–2019
Gross Alpha, Excl. Radon And U
8.636 pCi/L 58%
of the EPA limit 15 pCi/L
worst single sample: 9 pCi/L
3/6 SYR4 2012–2019
Combined Uranium
5.99 µg/L 20%
of the EPA limit 30 µg/L
worst single sample: 6 µg/L
2/2 SYR4 2016–2019
Chromium
5 µg/L 5%
of the EPA limit 100 µg/L
1/9 SYR4 2013–2019
Dichloroacetic Acid
3.3 µg/L
No EPA limit set
1/8 SYR4 2013–2019
Monobromoacetic Acid
0.5300 µg/L
No EPA limit set
1/8 SYR4 2013–2019
52 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonochloroacetic AcidOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
BROOKSHIRE, PEYTON
Phone
406-322-4424
Email
[email protected]

Frequently asked questions about Columbus Town of

Is Columbus Town of tap water safe to drink?

EPA monitoring detected 20 contaminants in Columbus Town of's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Columbus Town of's water?

EPA monitoring detected Nitrate-Nitrite, Copper, Lead, Arsenic, Lead, and others. The full list with the level and data source for each is above.

How many people does Columbus Town of serve?

Columbus Town of reports serving 1,900 people in Montana, per its EPA record.

Has Columbus Town of had any water quality violations?

The EPA has 186 violations on file for Columbus Town of, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.