← Minnesota

Tap water quality report

Howard Lake

EPA monitoring tested this supplier for 47 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

47
contaminants tested
10
detected
2,180
people served
6
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Wright

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

6
health-based violations
30
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 1987-10-01 → 1991-09-30
MCL Health-based Resolved 1987-10-01 → 1991-09-30
MCL Health-based Resolved 1987-10-01 → 1991-09-30
MCL Health-based Resolved 1987-10-01 → 1991-09-30
MCL Health-based Resolved 1987-10-01 → 1991-09-30
MCL Health-based Resolved 1987-10-01 → 1991-09-30
MR Monitoring Resolved 2022-01-01
MR Monitoring Resolved 2022-01-01
MR Monitoring Resolved 2022-01-01
MR Monitoring Resolved 2013-09-01 → 2013-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Fluoride
1100 µg/L 28%
of the EPA limit 4000 µg/L
worst single sample: 1400 µg/L
32/32 SYR4 2012–2019
Copper
1493 µg/L 115%
of the EPA limit, at the 95th percentile of samples — 1300 µg/L
worst single sample: 1720 µg/L
30/30 SYR4 2012–2018
Lead
3.62 µg/L 24%
of the EPA limit 15 µg/L
worst single sample: 5.7 µg/L
17/30 SYR4 2012–2018
Nitrate-Nitrite
1000 µg/L 10%
of the EPA limit 10000 µg/L
14/16 SYR4 2012–2019
Chloroform
1.82 µg/L
No EPA limit set
worst single sample: 1.9 µg/L
9/9 SYR4 2013–2019
Bromodichloromethane
0.8700 µg/L
No EPA limit set
worst single sample: 0.9000 µg/L
4/9 SYR4 2013–2019
Arsenic
7.281 µg/L 73%
of the EPA limit 10 µg/L
worst single sample: 7.63 µg/L
3/3 SYR4 2013–2019
Lead
0.0150 mg/L 100%
of the EPA limit 0.0150 mg/L
3/3 LCR 2024
Barium
99 µg/L 5%
of the EPA limit 2000 µg/L
1/1 SYR4 2013
Dichloroacetic Acid
2.2 µg/L
No EPA limit set
1/8 SYR4 2013–2019
37 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalBenzeneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneDibromoacetic AcidDibromochloromethaneEthylene DibromideEthylbenzeneGross Alpha, Excl. Radon And UMercuryMonobromoacetic AcidMonochloroacetic AcidSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroacetic AcidTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Phone
3205433670
Email
[email protected]

Frequently asked questions about Howard Lake

Is Howard Lake tap water safe to drink?

EPA monitoring detected 10 contaminants in Howard Lake's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Howard Lake's water?

EPA monitoring detected Fluoride, Copper, Lead, Nitrate-Nitrite, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Howard Lake serve?

Howard Lake reports serving 2,180 people in Minnesota, per its EPA record.

Has Howard Lake had any water quality violations?

The EPA has 30 violations on file for Howard Lake, of which 6 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.