← Maine

Tap water quality report

Baileyville Utilities District

EPA monitoring tested this supplier for 50 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
12
detected
1,688
people served
15
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Washington

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

15
health-based violations
37
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 1996-10-01 → 1996-10-31
MCL Health-based Resolved 1996-10-01 → 1996-10-31
MCL Health-based Resolved 1996-10-01 → 1996-10-31
MCL Health-based Resolved 1996-10-01 → 1996-10-31
MCL Health-based Resolved 1996-08-01 → 1996-08-31
MCL Health-based Resolved 1996-08-01 → 1996-08-31
MCL Health-based Resolved 1996-08-01 → 1996-08-31
MCL Health-based Resolved 1996-07-01 → 1996-07-31
MCL Health-based Resolved 1996-07-01 → 1996-07-31
MCL Health-based Resolved 1996-07-01 → 1996-07-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Fluoride
831.5 µg/L 21%
of the EPA limit 4000 µg/L
worst single sample: 1100 µg/L
98/98 SYR4 2012–2019
Copper
130 µg/L 10%
of the EPA limit 1300 µg/L
worst single sample: 450 µg/L
22/22 SYR4 2014–2017
Lead
2.79 µg/L 19%
of the EPA limit 15 µg/L
worst single sample: 3 µg/L
15/22 SYR4 2014–2017
Lead
0.0037 mg/L 25%
of the EPA limit 0.0150 mg/L
14/14 LCR 2023
Arsenic
1.625 µg/L 16%
of the EPA limit 10 µg/L
worst single sample: 1.8 µg/L
8/11 SYR4 2012–2019
Nitrate
120 µg/L 1.2%
of the EPA limit 10000 µg/L
4/18 SYR4 2012–2019
Barium
3.885 µg/L 0.2%
of the EPA limit 2000 µg/L
worst single sample: 3.9 µg/L
2/2 SYR4 2014–2017
Chromium
1.68 µg/L 1.7%
of the EPA limit 100 µg/L
worst single sample: 1.7 µg/L
2/2 SYR4 2014–2017
Bromodichloromethane
1.7 µg/L
No EPA limit set
1/13 SYR4 2012–2019
Chloroform
1.5 µg/L
No EPA limit set
1/13 SYR4 2012–2019
Dibromochloromethane
1.4 µg/L
No EPA limit set
1/13 SYR4 2012–2019
TTHM
4.6 µg/L 5.8%
of the EPA limit 80 µg/L
1/5 SYR4 2014–2019
38 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalBenzeneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbon TetrachlorideCombined UraniumDichloromethaneDibromoacetic AcidDichloroacetic AcidEthylbenzeneGross Alpha, Excl. Radon And UMercuryMonobromoacetic AcidMonochloroacetic AcidSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
HAFFORD, ANNALEIS
Phone
207-223-2232
Email
[email protected]

Frequently asked questions about Baileyville Utilities District

Is Baileyville Utilities District tap water safe to drink?

EPA monitoring detected 12 contaminants in Baileyville Utilities District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Baileyville Utilities District's water?

EPA monitoring detected Fluoride, Copper, Lead, Lead, Arsenic, and others. The full list with the level and data source for each is above.

How many people does Baileyville Utilities District serve?

Baileyville Utilities District reports serving 1,688 people in Maine, per its EPA record.

Has Baileyville Utilities District had any water quality violations?

The EPA has 37 violations on file for Baileyville Utilities District, of which 15 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.