Tap WaterIndex

← Maryland

Tap water quality report

Nantucket Point(Distribution-Delaware)

EPA monitoring tested this supplier for 12 contaminants and detected 9. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

12
contaminants tested
9
detected
500
people served
4
health-based violations
Maryland rankingsLead in MarylandPFAS in Maryland
Water source
GWP
Ownership
Local government
Counties served
Worcester

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
67
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2002-07-01 → 2002-07-31
MCL Health-based Resolved 2002-07-01 → 2002-07-31
MCL Health-based Resolved 2002-07-01 → 2002-07-31
MCL Health-based Resolved 2002-07-01 → 2002-07-31
MR Monitoring Resolved 1998-01-01 → 1998-12-31
MR Monitoring Resolved 1998-01-01 → 1998-12-31
MR Monitoring Resolved 1998-01-01 → 1998-12-31
MR Monitoring Resolved 1998-01-01 → 1998-12-31
MR Monitoring Resolved 1998-01-01 → 1998-12-31
MR Monitoring Resolved 1998-01-01 → 1998-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Total Haloacetic Acids (HAA5)
50.98 µg/L 85%
of the EPA limit 60 µg/L
worst single sample: 58.8 µg/L
27/27 SYR4 2012–2019
TTHM
93.615 µg/L 117%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 112.52 µg/L
26/27 SYR4 2012–2019
Bromodichloromethane
21.59 µg/L
No EPA limit set
worst single sample: 22.5 µg/L
23/23 SYR4 2012–2016
Chloroform
75.04 µg/L
No EPA limit set
worst single sample: 88.6 µg/L
23/23 SYR4 2012–2016
Dibromochloromethane
6.945 µg/L
No EPA limit set
worst single sample: 7.1 µg/L
23/23 SYR4 2012–2016
Dichloroacetic Acid
25.12 µg/L
No EPA limit set
worst single sample: 27 µg/L
23/23 SYR4 2012–2016
Trichloroacetic Acid
31.61 µg/L
No EPA limit set
worst single sample: 33.6 µg/L
23/23 SYR4 2012–2016
Lead
0.0020 mg/L 13%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2018
Dibromoacetic Acid
1.8875 µg/L
No EPA limit set
worst single sample: 2 µg/L
4/23 SYR4 2012–2016
3 contaminants tested, none detected
BromoformMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact
GLENN, ANDY
Phone
443-523-6642
Email
[email protected]

Frequently asked questions about Nantucket Point(Distribution-Delaware)

Is Nantucket Point(Distribution-Delaware) tap water safe to drink?

EPA monitoring detected 9 contaminants in Nantucket Point(Distribution-Delaware)'s water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Nantucket Point(Distribution-Delaware)'s water?

EPA monitoring detected Total Haloacetic Acids (HAA5), TTHM, Bromodichloromethane, Chloroform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Nantucket Point(Distribution-Delaware) serve?

Nantucket Point(Distribution-Delaware) reports serving 500 people in Maryland, per its EPA record.

Has Nantucket Point(Distribution-Delaware) had any water quality violations?

The EPA has 67 violations on file for Nantucket Point(Distribution-Delaware), of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.