Tap WaterIndex

← Maryland

Tap water quality report

Millington Distribution

EPA monitoring tested this supplier for 11 contaminants and detected 7. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

11
contaminants tested
7
detected
260
people served
0
health-based violations
Maryland rankingsLead in MarylandPFAS in Maryland
Water source
GWP
Ownership
Local government
Counties served
Kent

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
1
violations on file
0
still open
ViolationTypeStatusPeriod
RPT Monitoring Resolved 2025-07-02

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
6.61 µg/L 8.3%
of the EPA limit 80 µg/L
worst single sample: 6.7 µg/L
3/3 SYR4 2013–2017
Total Haloacetic Acids (HAA5)
1.86 µg/L 3.1%
of the EPA limit 60 µg/L
worst single sample: 1.9 µg/L
3/3 SYR4 2013–2017
Bromodichloromethane
1.6705 µg/L
No EPA limit set
worst single sample: 1.7 µg/L
2/2 SYR4 2013–2014
Chloroform
2.8625 µg/L
No EPA limit set
worst single sample: 2.9 µg/L
2/2 SYR4 2013–2014
Dibromochloromethane
1.1805 µg/L
No EPA limit set
worst single sample: 1.2 µg/L
2/2 SYR4 2013–2014
Dichloroacetic Acid
1.4945 µg/L
No EPA limit set
worst single sample: 1.5 µg/L
2/2 SYR4 2013–2014
Trichloroacetic Acid
0.5100 µg/L
No EPA limit set
 1/2 SYR4 2013–2014
4 contaminants tested, none detected
BromoformDibromoacetic AcidMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact
SWARTZ, GREG
Phone
410-778-3287
Email
[email protected]

Frequently asked questions about Millington Distribution

Is Millington Distribution tap water safe to drink?

EPA monitoring detected 7 contaminants in Millington Distribution's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Millington Distribution's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Bromodichloromethane, Chloroform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Millington Distribution serve?

Millington Distribution reports serving 260 people in Maryland, per its EPA record.

Has Millington Distribution had any water quality violations?

The EPA has 1 violation on file for Millington Distribution, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.