← Maryland

Tap water quality report

Perry Point V.A. Medical Center

EPA monitoring tested this supplier for 75 contaminants and detected 15. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

75
contaminants tested
15
detected
2,000
people served
52
health-based violations
Water source
Surface water
Ownership
Federal government
Counties served
Cecil

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

52
health-based violations
222
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2017-07-01 → 2017-09-30
MCL Health-based Resolved 2017-07-01 → 2017-09-30
MCL Health-based Resolved 2017-07-01 → 2017-09-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-01-01 → 2017-03-31
MCL Health-based Resolved 2017-01-01 → 2017-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
122.5 µg/L 153%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 179.8 µg/L
56/56 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
89.1 µg/L 149%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 155 µg/L
55/56 SYR4 2012–2019
Bromodichloromethane
24 µg/L
No EPA limit set
worst single sample: 26 µg/L
41/41 SYR4 2012–2019
Chloroform
100 µg/L
No EPA limit set
worst single sample: 150 µg/L
41/41 SYR4 2012–2019
Dibromochloromethane
6.095 µg/L
No EPA limit set
worst single sample: 8.1 µg/L
36/41 SYR4 2012–2019
Dichloroacetic Acid
31.4 µg/L
No EPA limit set
worst single sample: 42 µg/L
33/33 SYR4 2012–2015
Trichloroacetic Acid
37.1 µg/L
No EPA limit set
worst single sample: 51 µg/L
32/33 SYR4 2012–2015
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
14/14 LCR 2024
Monochloroacetic Acid
4.12 µg/L
No EPA limit set
worst single sample: 4.2 µg/L
9/33 SYR4 2012–2015
Nitrate
1500 µg/L 15%
of the EPA limit 10000 µg/L
8/20 SYR4 2012–2019
Barium
194 µg/L 9.7%
of the EPA limit 2000 µg/L
worst single sample: 260 µg/L
7/15 SYR4 2012–2019
Nitrate-Nitrite
850 µg/L 8.5%
of the EPA limit 10000 µg/L
worst single sample: 860 µg/L
3/3 SYR4 2015–2017
Dalapon
1.2265 µg/L 0.6%
of the EPA limit 200 µg/L
worst single sample: 1.23 µg/L
2/6 SYR4 2013–2018
Dibromoacetic Acid
2 µg/L
No EPA limit set
1/33 SYR4 2012–2015
Fluoride
560 µg/L 14%
of the EPA limit 4000 µg/L
1/15 SYR4 2012–2019
60 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined Radium (-226 And -228)DichloromethaneDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneGross Alpha, Excl. Radon And UGross Beta Particle ActivityHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
JOHNSON, ROBERT
Phone
410-642-2411
Email
[email protected]

Frequently asked questions about Perry Point V.A. Medical Center

Is Perry Point V.A. Medical Center tap water safe to drink?

EPA monitoring detected 15 contaminants in Perry Point V.A. Medical Center's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Perry Point V.A. Medical Center's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Bromodichloromethane, Chloroform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Perry Point V.A. Medical Center serve?

Perry Point V.A. Medical Center reports serving 2,000 people in Maryland, per its EPA record.

Has Perry Point V.A. Medical Center had any water quality violations?

The EPA has 222 violations on file for Perry Point V.A. Medical Center, of which 52 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.