← Massachusetts

Tap water quality report

Bondsville Fire and Water District

EPA monitoring tested this supplier for 61 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

61
contaminants tested
5
detected
1,429
people served
2
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Hampden

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

2
health-based violations
47
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2004-09-01 → 2004-09-30
MCL Health-based Archived 1993-09-01 → 1993-09-30
MR Monitoring Archived 2015-01-01 → 2015-01-31
MR Monitoring Resolved 2011-10-01 → 2011-12-31
MR Monitoring Resolved 2011-10-01 → 2011-12-31
MR Monitoring Resolved 2011-10-01 → 2011-12-31
MR Monitoring Resolved 2011-10-01 → 2011-12-31
MR Monitoring Resolved 2011-10-01 → 2011-12-31
MR Monitoring Resolved 2011-10-01 → 2011-12-31
MR Monitoring Resolved 2011-10-01 → 2011-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
4800 µg/L 48%
of the EPA limit 10000 µg/L
28/28 SYR4 2013–2019
Lead
0.0013 mg/L 8.7%
of the EPA limit 0.0150 mg/L
22/22 LCR 2025
Barium
190 µg/L 9.5%
of the EPA limit 2000 µg/L
4/4 SYR4 2014–2017
Cyanide
13.9 µg/L 7%
of the EPA limit 200 µg/L
worst single sample: 14 µg/L
2/4 SYR4 2014–2017
Fluoride
200 µg/L 5%
of the EPA limit 4000 µg/L
1/4 SYR4 2014–2017
56 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
ROBERT J FLAGG
Phone
4132831627
Email
[email protected]

Frequently asked questions about Bondsville Fire and Water District

Is Bondsville Fire and Water District tap water safe to drink?

EPA monitoring detected 5 contaminants in Bondsville Fire and Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Bondsville Fire and Water District's water?

EPA monitoring detected Nitrate, Lead, Barium, Cyanide, Fluoride. The full list with the level and data source for each is above.

How many people does Bondsville Fire and Water District serve?

Bondsville Fire and Water District reports serving 1,429 people in Massachusetts, per its EPA record.

Has Bondsville Fire and Water District had any water quality violations?

The EPA has 47 violations on file for Bondsville Fire and Water District, of which 2 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.