← Kentucky

Tap water quality report

Beaver Dam Municipal Water & Sewer

EPA monitoring tested this supplier for 99 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

99
contaminants tested
10
detected
3,901
people served
8
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Ohio

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

8
health-based violations
122
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2020-07-01
TT Health-based Resolved 2020-07-01
TT Health-based Resolved 2020-07-01
TT Health-based Resolved 2020-07-01
MCL Health-based Resolved 2003-08-01 → 2003-08-31
MCL Health-based Resolved 2003-08-01 → 2003-08-31
MCL Health-based Resolved 2003-08-01 → 2003-08-31
MCL Health-based Resolved 2003-08-01 → 2003-08-31
Other Monitoring Resolved 2021-07-01
Other Monitoring Resolved 2021-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
72.15 µg/L 90%
of the EPA limit 80 µg/L
worst single sample: 101 µg/L
34/51 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
51.8 µg/L 86%
of the EPA limit 60 µg/L
worst single sample: 73 µg/L
34/51 SYR4 2012–2019
Copper
623.75 µg/L 48%
of the EPA limit 1300 µg/L
worst single sample: 1330 µg/L
32/39 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
14/14 LCR 2025
Lead
3.415 µg/L 23%
of the EPA limit 15 µg/L
worst single sample: 4 µg/L
14/31 SYR4 2013–2019
Fluoride
320 µg/L 8%
of the EPA limit 4000 µg/L
worst single sample: 400 µg/L
9/10 SYR4 2012–2019
Nitrate
128 µg/L 1.3%
of the EPA limit 10000 µg/L
4/30 SYR4 2012–2019
Barium
36.9 µg/L 1.8%
of the EPA limit 2000 µg/L
worst single sample: 37 µg/L
2/2 SYR4 2014–2017
Lithium
10.1 µg/L
No EPA limit set
2/4 UCMR-5 2023
Combined Radium (-226 And -228)
0.4850 pCi/L 9.7%
of the EPA limit 5 pCi/L
1/1 SYR4 2019
89 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNetfosaaNfdhaNmefosaaOxamylPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
CARTER, TRAVIS
Phone
270-256-8002
Email
[email protected]

Frequently asked questions about Beaver Dam Municipal Water & Sewer

Is Beaver Dam Municipal Water & Sewer tap water safe to drink?

EPA monitoring detected 10 contaminants in Beaver Dam Municipal Water & Sewer's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Beaver Dam Municipal Water & Sewer's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, Lead, and others. The full list with the level and data source for each is above.

How many people does Beaver Dam Municipal Water & Sewer serve?

Beaver Dam Municipal Water & Sewer reports serving 3,901 people in Kentucky, per its EPA record.

Has Beaver Dam Municipal Water & Sewer had any water quality violations?

The EPA has 122 violations on file for Beaver Dam Municipal Water & Sewer, of which 8 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.