Tap WaterIndex

← Kentucky

Tap water quality report

Reid Village Water District

EPA monitoring tested this supplier for 5 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

5
contaminants tested
5
detected
2,545
people served
105
health-based violations
Kentucky rankingsLead in KentuckyPFAS in Kentucky
Water source
SWP
Ownership
Local government
Counties served
Montgomery

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

105
health-based violations
166
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2023-07-01 → 2023-09-30
MCL Health-based Resolved 2023-07-01 → 2023-09-30
MCL Health-based Resolved 2023-07-01 → 2023-09-30
MCL Health-based Resolved 2023-07-01 → 2023-09-30
MCL Health-based Resolved 2023-07-01 → 2023-09-30
MCL Health-based Resolved 2023-04-01 → 2023-06-30
MCL Health-based Resolved 2023-04-01 → 2023-06-30
MCL Health-based Resolved 2023-04-01 → 2023-06-30
MCL Health-based Resolved 2023-04-01 → 2023-06-30
MCL Health-based Resolved 2023-04-01 → 2023-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
118.45 µg/L 148%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 185 µg/L
51/51 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
107.5 µg/L 179%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 133 µg/L
51/51 SYR4 2013–2019
Copper
103.85 µg/L 8%
of the EPA limit 1300 µg/L
worst single sample: 122 µg/L
30/30 SYR4 2014–2017
Lead
0.0020 mg/L 13%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2023
Lead
20.3 µg/L 135%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 39 µg/L
12/30 SYR4 2014–2017

Utility contact

Contact
CARTMILL, RACHEL
Phone
859-498-0062
Email
[email protected]

Frequently asked questions about Reid Village Water District

Is Reid Village Water District tap water safe to drink?

EPA monitoring detected 5 contaminants in Reid Village Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Reid Village Water District's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, Lead. The full list with the level and data source for each is above.

How many people does Reid Village Water District serve?

Reid Village Water District reports serving 2,545 people in Kentucky, per its EPA record.

Has Reid Village Water District had any water quality violations?

The EPA has 166 violations on file for Reid Village Water District, of which 105 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.