Tap WaterIndex

← Kentucky

Tap water quality report

Doe Valley Utilities Inc

EPA monitoring tested this supplier for 5 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

5
contaminants tested
5
detected
2,260
people served
8
health-based violations
Kentucky rankingsLead in KentuckyPFAS in Kentucky
Water source
GWP
Ownership
Private
Counties served
Meade

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

8
health-based violations
88
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2005-01-01 → 2005-03-31
MCL Health-based Resolved 2005-01-01 → 2005-03-31
MCL Health-based Resolved 2005-01-01 → 2005-03-31
MCL Health-based Resolved 2005-01-01 → 2005-03-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31
Other Monitoring Resolved 2008-07-01
Other Monitoring Resolved 2008-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
53.71 µg/L 67%
of the EPA limit 80 µg/L
worst single sample: 61.9 µg/L
50/50 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
58.235 µg/L 97%
of the EPA limit 60 µg/L
worst single sample: 81.4 µg/L
50/50 SYR4 2013–2019
Copper
611.8 µg/L 47%
of the EPA limit 1300 µg/L
worst single sample: 836 µg/L
32/32 SYR4 2013–2019
Lead
10.05 µg/L 67%
of the EPA limit 15 µg/L
worst single sample: 12 µg/L
14/32 SYR4 2013–2019
Lead
0.0040 mg/L 27%
of the EPA limit 0.0150 mg/L
 13/13 LCR 2025

Utility contact

Contact
BOHANNON, EDDIE
Phone
270-422-2188
Email
[email protected]

Frequently asked questions about Doe Valley Utilities Inc

Is Doe Valley Utilities Inc tap water safe to drink?

EPA monitoring detected 5 contaminants in Doe Valley Utilities Inc's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Doe Valley Utilities Inc's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, Lead. The full list with the level and data source for each is above.

How many people does Doe Valley Utilities Inc serve?

Doe Valley Utilities Inc reports serving 2,260 people in Kentucky, per its EPA record.

Has Doe Valley Utilities Inc had any water quality violations?

The EPA has 88 violations on file for Doe Valley Utilities Inc, of which 8 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.