← Kentucky

Tap water quality report

Madison Co Utilities District

EPA monitoring tested this supplier for 35 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

35
contaminants tested
5
detected
25,120
people served
33
health-based violations
Water source
SWP
Ownership
Local government
Counties served
Madison

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

33
health-based violations
102
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2019-06-01 → 2019-06-30
MCL Health-based Resolved 2019-06-01 → 2019-06-30
MCL Health-based Resolved 2019-06-01 → 2019-06-30
MCL Health-based Resolved 2019-06-01 → 2019-06-30
MCL Health-based Resolved 2019-06-01 → 2019-06-30
MCL Health-based Resolved 2019-06-01 → 2019-06-30
MCL Health-based Resolved 2019-06-01 → 2019-06-30
MCL Health-based Resolved 2019-06-01 → 2019-06-30
MCL Health-based Resolved 2011-09-01 → 2011-09-30
MCL Health-based Resolved 2011-09-01 → 2011-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
95.2 µg/L 119%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 133 µg/L
100/100 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
60.05 µg/L 100%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 81 µg/L
100/100 SYR4 2013–2019
Copper
174.5 µg/L 13%
of the EPA limit 1300 µg/L
worst single sample: 573 µg/L
91/91 SYR4 2012–2018
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
12/12 LCR 2024
Lead
4.755 µg/L 32%
of the EPA limit 15 µg/L
worst single sample: 4.9 µg/L
2/91 SYR4 2012–2018
30 contaminants tested, none detected
11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaHfpo-DaNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaLithium

Utility contact

Contact
WEBB, JARED
Phone
859-582-2409
Email
[email protected]

Frequently asked questions about Madison Co Utilities District

Is Madison Co Utilities District tap water safe to drink?

EPA monitoring detected 5 contaminants in Madison Co Utilities District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Madison Co Utilities District's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, Lead. The full list with the level and data source for each is above.

How many people does Madison Co Utilities District serve?

Madison Co Utilities District reports serving 25,120 people in Kentucky, per its EPA record.

Has Madison Co Utilities District had any water quality violations?

The EPA has 102 violations on file for Madison Co Utilities District, of which 33 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.