Tap WaterIndex

← Kentucky

Tap water quality report

Sacramento Water Works

EPA monitoring tested this supplier for 5 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

5
contaminants tested
5
detected
2,435
people served
16
health-based violations
Kentucky rankingsLead in KentuckyPFAS in Kentucky
Water source
SWP
Ownership
Local government
Counties served
McLean

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

16
health-based violations
47
violations on file
1
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2018-04-01 → 2018-06-30
MCL Health-based Resolved 2018-04-01 → 2018-06-30
MCL Health-based Resolved 2018-04-01 → 2018-06-30
MCL Health-based Resolved 2018-04-01 → 2018-06-30
MCL Health-based Resolved 2018-01-01 → 2018-03-31
MCL Health-based Resolved 2018-01-01 → 2018-03-31
MCL Health-based Resolved 2018-01-01 → 2018-03-31
MCL Health-based Resolved 2018-01-01 → 2018-03-31
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2017-10-01 → 2017-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
102.75 µg/L 128%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 119 µg/L
50/50 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
70 µg/L 117%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 98 µg/L
50/50 SYR4 2013–2019
Copper
55.93 µg/L 4.3%
of the EPA limit 1300 µg/L
worst single sample: 382 µg/L
19/20 SYR4 2014–2017
Lead
0.0038 mg/L 25%
of the EPA limit 0.0150 mg/L
 12/12 LCR 2023
Lead
4 µg/L 27%
of the EPA limit 15 µg/L
 1/20 SYR4 2014–2017

Utility contact

Contact
SALLEE, JAMES R
Phone
270-736-5114
Email
[email protected]

Frequently asked questions about Sacramento Water Works

Is Sacramento Water Works tap water safe to drink?

EPA monitoring detected 5 contaminants in Sacramento Water Works's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Sacramento Water Works's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, Lead. The full list with the level and data source for each is above.

How many people does Sacramento Water Works serve?

Sacramento Water Works reports serving 2,435 people in Kentucky, per its EPA record.

Has Sacramento Water Works had any water quality violations?

The EPA has 47 violations on file for Sacramento Water Works, of which 16 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.