Tap WaterIndex

← Kentucky

Tap water quality report

Auburn Mun Water Works

EPA monitoring tested this supplier for 5 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

5
contaminants tested
5
detected
1,931
people served
13
health-based violations
Kentucky rankingsLead in KentuckyPFAS in Kentucky
Water source
SWP
Ownership
Local government
Counties served
Logan

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

13
health-based violations
100
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2022-04-01 → 2022-06-30
MCL Health-based Resolved 2022-04-01 → 2022-06-30
MCL Health-based Resolved 2022-04-01 → 2022-06-30
MCL Health-based Resolved 2022-04-01 → 2022-06-30
TT Health-based Resolved 2002-11-01 → 2002-11-30
TT Health-based Resolved 2002-11-01 → 2002-11-30
TT Health-based Resolved 2002-11-01 → 2002-11-30
TT Health-based Resolved 2002-11-01 → 2002-11-30
TT Health-based Resolved 2002-11-01 → 2002-11-30
TT Health-based Resolved 2002-11-01 → 2002-11-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Total Haloacetic Acids (HAA5)
53.3 µg/L 89%
of the EPA limit 60 µg/L
worst single sample: 66.6 µg/L
45/45 SYR4 2014–2019
TTHM
98.365 µg/L 123%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 106 µg/L
44/44 SYR4 2014–2019
Copper
44.61 µg/L 3.4%
of the EPA limit 1300 µg/L
worst single sample: 84.7 µg/L
20/20 SYR4 2014–2017
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 13/13 LCR 2023
Lead
1.86 µg/L 12%
of the EPA limit 15 µg/L
worst single sample: 2 µg/L
5/20 SYR4 2014–2017

Utility contact

Contact
GATES, BRANDON
Phone
270-542-4475
Email
[email protected]

Frequently asked questions about Auburn Mun Water Works

Is Auburn Mun Water Works tap water safe to drink?

EPA monitoring detected 5 contaminants in Auburn Mun Water Works's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Auburn Mun Water Works's water?

EPA monitoring detected Total Haloacetic Acids (HAA5), TTHM, Copper, Lead, Lead. The full list with the level and data source for each is above.

How many people does Auburn Mun Water Works serve?

Auburn Mun Water Works reports serving 1,931 people in Kentucky, per its EPA record.

Has Auburn Mun Water Works had any water quality violations?

The EPA has 100 violations on file for Auburn Mun Water Works, of which 13 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.