← Kentucky

Tap water quality report

Allen County Water District

EPA monitoring tested this supplier for 35 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

35
contaminants tested
5
detected
16,398
people served
17
health-based violations
Water source
SWP
Ownership
Local government
Counties served
Allen

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

17
health-based violations
31
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2016-04-01 → 2016-06-30
MCL Health-based Resolved 2016-04-01 → 2016-06-30
MCL Health-based Resolved 2016-04-01 → 2016-06-30
MCL Health-based Resolved 2016-04-01 → 2016-06-30
MCL Health-based Resolved 2016-01-01 → 2016-03-31
MCL Health-based Resolved 2016-01-01 → 2016-03-31
MCL Health-based Resolved 2016-01-01 → 2016-03-31
MCL Health-based Resolved 2016-01-01 → 2016-03-31
MCL Health-based Resolved 2015-10-01 → 2015-12-31
MCL Health-based Resolved 2015-10-01 → 2015-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
89.25 µg/L 112%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 118 µg/L
100/100 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
62.1 µg/L 103%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 98 µg/L
100/100 SYR4 2013–2019
Copper
72.2 µg/L 5.6%
of the EPA limit 1300 µg/L
worst single sample: 283 µg/L
60/60 SYR4 2014–2017
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
12/12 LCR 2023
Lead
41.5 µg/L 277%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 54 µg/L
6/60 SYR4 2014–2017
30 contaminants tested, none detected
11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaHfpo-DaNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaLithium

Utility contact

Contact
NUNN, ADAM
Phone
270-622-3040
Email
[email protected]

Frequently asked questions about Allen County Water District

Is Allen County Water District tap water safe to drink?

EPA monitoring detected 5 contaminants in Allen County Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Allen County Water District's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, Lead. The full list with the level and data source for each is above.

How many people does Allen County Water District serve?

Allen County Water District reports serving 16,398 people in Kentucky, per its EPA record.

Has Allen County Water District had any water quality violations?

The EPA has 31 violations on file for Allen County Water District, of which 17 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.