← Kansas

Tap water quality report

Franklin Co Rwd 6

EPA monitoring tested this supplier for 62 contaminants and detected 21. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

62
contaminants tested
21
detected
2,960
people served
93
health-based violations
Water source
Surface water
Ownership
Local government
Counties served
Franklin

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

93
health-based violations
94
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
92.95 µg/L 116%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 110 µg/L
32/32 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
83.5 µg/L 139%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 130 µg/L
31/32 SYR4 2012–2019
Bromodichloromethane
26.55 µg/L
No EPA limit set
worst single sample: 40 µg/L
30/30 SYR4 2012–2019
Chloroform
57.8 µg/L
No EPA limit set
worst single sample: 83 µg/L
30/30 SYR4 2012–2019
Dibromochloromethane
12 µg/L
No EPA limit set
worst single sample: 14 µg/L
30/30 SYR4 2012–2019
Dichloroacetic Acid
39.65 µg/L
No EPA limit set
worst single sample: 76 µg/L
30/30 SYR4 2012–2019
Trichloroacetic Acid
27 µg/L
No EPA limit set
worst single sample: 47 µg/L
30/30 SYR4 2012–2019
Copper
639 µg/L 49%
of the EPA limit 1300 µg/L
worst single sample: 790 µg/L
28/28 SYR4 2012–2019
Dibromoacetic Acid
4.1 µg/L
No EPA limit set
worst single sample: 4.7 µg/L
28/30 SYR4 2012–2019
Nitrate
1920 µg/L 19%
of the EPA limit 10000 µg/L
worst single sample: 2200 µg/L
28/32 SYR4 2012–2019
Monobromoacetic Acid
2.57 µg/L
No EPA limit set
worst single sample: 21 µg/L
24/30 SYR4 2012–2019
Monochloroacetic Acid
9.1 µg/L
No EPA limit set
worst single sample: 19 µg/L
21/30 SYR4 2012–2019
Bromoform
2.03 µg/L
No EPA limit set
worst single sample: 2.6 µg/L
20/30 SYR4 2012–2019
Lead
7.44 µg/L 50%
of the EPA limit 15 µg/L
worst single sample: 15 µg/L
19/28 SYR4 2012–2019
Atrazine
2.34 µg/L 78%
of the EPA limit 3 µg/L
worst single sample: 2.5 µg/L
9/10 SYR4 2012–2019
Barium
113 µg/L 5.7%
of the EPA limit 2000 µg/L
worst single sample: 120 µg/L
8/8 SYR4 2012–2019
Selenium
3.99 µg/L 8%
of the EPA limit 50 µg/L
worst single sample: 4.2 µg/L
8/8 SYR4 2012–2019
Lead
0.0053 mg/L 35%
of the EPA limit 0.0150 mg/L
7/7 LCR 2023
Arsenic
1.64 µg/L 16%
of the EPA limit 10 µg/L
worst single sample: 1.7 µg/L
5/8 SYR4 2012–2019
Chromium
3.1 µg/L 3.1%
of the EPA limit 100 µg/L
worst single sample: 3.2 µg/L
5/8 SYR4 2012–2019
Fluoride
244 µg/L 6.1%
of the EPA limit 4000 µg/L
worst single sample: 250 µg/L
5/8 SYR4 2012–2019
41 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalBhc-GammaBenzeneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneCombined Radium (-226 And -228)DichloromethaneEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
TITUS, RICK
Phone
785-878-3388
Email
[email protected]

Frequently asked questions about Franklin Co Rwd 6

Is Franklin Co Rwd 6 tap water safe to drink?

EPA monitoring detected 21 contaminants in Franklin Co Rwd 6's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Franklin Co Rwd 6's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Bromodichloromethane, Chloroform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Franklin Co Rwd 6 serve?

Franklin Co Rwd 6 reports serving 2,960 people in Kansas, per its EPA record.

Has Franklin Co Rwd 6 had any water quality violations?

The EPA has 94 violations on file for Franklin Co Rwd 6, of which 93 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.