Tap WaterIndex

← Kansas

Tap water quality report

Belpre, City of

EPA monitoring tested this supplier for 50 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
13
detected
98
people served
24
health-based violations
Kansas rankingsLead in KansasPFAS in Kansas
Water source
Ground water
Ownership
Local government
Counties served
Edwards

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

24
health-based violations
140
violations on file
2
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2002-04-01 → 2002-06-30
MCL Health-based Resolved 2002-04-01 → 2002-06-30
MCL Health-based Resolved 2002-04-01 → 2002-06-30
MCL Health-based Resolved 2002-04-01 → 2002-06-30
MCL Health-based Resolved 2001-10-01 → 2001-12-31
MCL Health-based Resolved 2001-10-01 → 2001-12-31
MCL Health-based Resolved 2001-10-01 → 2001-12-31
MCL Health-based Resolved 2001-10-01 → 2001-12-31
MCL Health-based Resolved 1998-09-01 → 1998-09-30
MCL Health-based Resolved 1998-09-01 → 1998-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
12825 µg/L 128%
of the EPA limit, at the 95th percentile of samples — 10000 µg/L
worst single sample: 14000 µg/L
26/26 SYR4 2013–2019
Copper
430 µg/L 33%
of the EPA limit 1300 µg/L
worst single sample: 600 µg/L
18/18 SYR4 2013–2019
Lead
0.0134 mg/L 89%
of the EPA limit 0.0150 mg/L
 12/12 LCR 2025
Lead
17.65 µg/L 118%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 32 µg/L
11/18 SYR4 2013–2019
Barium
200 µg/L 10%
of the EPA limit 2000 µg/L
 2/2 SYR4 2013–2016
Fluoride
512.5 µg/L 13%
of the EPA limit 4000 µg/L
worst single sample: 520 µg/L
2/2 SYR4 2013–2016
Selenium
2.725 µg/L 5.5%
of the EPA limit 50 µg/L
worst single sample: 2.8 µg/L
2/2 SYR4 2013–2016
Bromodichloromethane
0.6000 µg/L
No EPA limit set
 1/4 SYR4 2013–2018
Bromoform
0.5400 µg/L
No EPA limit set
 1/4 SYR4 2013–2018
Chloroform
0.5100 µg/L
No EPA limit set
 1/4 SYR4 2013–2018
Chromium
3.2 µg/L 3.2%
of the EPA limit 100 µg/L
 1/2 SYR4 2013–2016
Combined Radium (-226 And -228)
0.9000 pCi/L 18%
of the EPA limit 5 pCi/L
 1/1 SYR4 2016
Dibromochloromethane
0.5900 µg/L
No EPA limit set
 1/4 SYR4 2013–2018
37 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicAtrazineBenzeneBeryllium, TotalChlorobenzeneCadmiumCarbon TetrachlorideDichloromethaneDibromoacetic AcidDichloroacetic AcidEthylene DibromideEthylbenzeneMercuryMonobromoacetic AcidMonochloroacetic AcidStyreneTTHMTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
STAPLETON, JERRY
Phone
620-995-3420
Email
[email protected]

Frequently asked questions about Belpre, City of

Is Belpre, City of tap water safe to drink?

EPA monitoring detected 13 contaminants in Belpre, City of's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Belpre, City of's water?

EPA monitoring detected Nitrate, Copper, Lead, Lead, Barium, and others. The full list with the level and data source for each is above.

How many people does Belpre, City of serve?

Belpre, City of reports serving 98 people in Kansas, per its EPA record.

Has Belpre, City of had any water quality violations?

The EPA has 140 violations on file for Belpre, City of, of which 24 are health-based (a contaminant limit or required treatment was breached) and 2 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.