Tap WaterIndex

← Indiana

Tap water quality report

Martinsville Water Utility

EPA monitoring tested this supplier for 102 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

102
contaminants tested
12
detected
15,000
people served
11
health-based violations
Indiana rankingsLead in IndianaPFAS in Indiana
Water source
Ground water
Ownership
Local government
Counties served
Morgan

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

11
health-based violations
42
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2004-09-01 → 2004-09-30
MCL Health-based Resolved 2004-09-01 → 2004-09-30
MCL Health-based Resolved 2004-09-01 → 2004-09-30
MCL Health-based Resolved 2004-09-01 → 2004-09-30
MCL Health-based Resolved 2004-09-01 → 2004-09-30
MCL Health-based Resolved 2002-01-01 → 2002-12-31
MCL Health-based Resolved 2002-01-01 → 2002-12-31
MCL Health-based Resolved 2002-01-01 → 2002-12-31
MCL Health-based Resolved 2002-01-01 → 2002-12-31
MCL Health-based Resolved 1995-04-01 → 1995-04-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
57.08 µg/L 71%
of the EPA limit 80 µg/L
worst single sample: 92.2 µg/L
97/107 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
8.95 µg/L 15%
of the EPA limit 60 µg/L
worst single sample: 35.6 µg/L
67/107 SYR4 2012–2019
Copper
528.25 µg/L 41%
of the EPA limit 1300 µg/L
worst single sample: 957 µg/L
30/30 SYR4 2017
Lead
0.0019 mg/L 13%
of the EPA limit 0.0150 mg/L
 26/26 LCR 2025
Nitrate
3812 µg/L 38%
of the EPA limit 10000 µg/L
 10/10 SYR4 2012–2016
Lead
7.48 µg/L 50%
of the EPA limit 15 µg/L
worst single sample: 9.4 µg/L
9/30 SYR4 2017
Nitrate-Nitrite
4040.5 µg/L 40%
of the EPA limit 10000 µg/L
worst single sample: 4075 µg/L
3/3 SYR4 2017–2019
Barium
70.325 µg/L 3.5%
of the EPA limit 2000 µg/L
worst single sample: 70.8 µg/L
2/2 SYR4 2014–2017
Selenium
1.4 µg/L 2.8%
of the EPA limit 50 µg/L
 2/2 SYR4 2014–2017
Fluoride
900 µg/L 23%
of the EPA limit 4000 µg/L
 1/2 SYR4 2014–2017
Gross Alpha, Excl. Radon And U
4.1 pCi/L 27%
of the EPA limit 15 pCi/L
 1/1 SYR4 2015
Tetrachloroethylene
1.1 µg/L 22%
of the EPA limit 5 µg/L
 1/34 SYR4 2012–2019
90 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChloroformChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromochloromethaneDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNetfosaaNfdhaNmefosaaOxamylPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaPentachlorophenolPicloramSimazineStyreneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
JOHNSON, JASON
Phone
765-341-0243
Email
[email protected]

Frequently asked questions about Martinsville Water Utility

Is Martinsville Water Utility tap water safe to drink?

EPA monitoring detected 12 contaminants in Martinsville Water Utility's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Martinsville Water Utility's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, Nitrate, and others. The full list with the level and data source for each is above.

How many people does Martinsville Water Utility serve?

Martinsville Water Utility reports serving 15,000 people in Indiana, per its EPA record.

Has Martinsville Water Utility had any water quality violations?

The EPA has 42 violations on file for Martinsville Water Utility, of which 11 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.