Tap WaterIndex

← Indiana

Tap water quality report

Culver Water Department

EPA monitoring tested this supplier for 72 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

72
contaminants tested
16
detected
1,391
people served
2
health-based violations
Indiana rankingsLead in IndianaPFAS in Indiana
Water source
Ground water
Ownership
Local government
Counties served
Marshall

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

2
health-based violations
88
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 1994-07-01
TT Health-based Resolved 1994-07-01
MR Monitoring Resolved 2019-01-01
MR Monitoring Resolved 2019-01-01
MR Monitoring Resolved 2012-12-01 → 2012-12-31
MR Monitoring Resolved 2012-12-01 → 2012-12-31
MR Monitoring Resolved 2012-12-01 → 2012-12-31
MR Monitoring Resolved 2012-12-01 → 2012-12-31
MR Monitoring Resolved 2012-12-01 → 2012-12-31
MR Monitoring Resolved 2012-10-01 → 2012-10-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Arsenic
3.83 µg/L 38%
of the EPA limit 10 µg/L
worst single sample: 6.6 µg/L
38/43 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
25.2 µg/L 42%
of the EPA limit 60 µg/L
worst single sample: 27.4 µg/L
11/12 SYR4 2012–2019
Copper
793.05 µg/L 61%
of the EPA limit 1300 µg/L
worst single sample: 1140 µg/L
10/10 SYR4 2018
TTHM
34.3 µg/L 43%
of the EPA limit 80 µg/L
worst single sample: 36.5 µg/L
9/11 SYR4 2012–2019
Lead
0.0017 mg/L 12%
of the EPA limit 0.0150 mg/L
 8/8 LCR 2024
Lead
5.44 µg/L 36%
of the EPA limit 15 µg/L
worst single sample: 6.4 µg/L
7/10 SYR4 2018
Barium
166.15 µg/L 8.3%
of the EPA limit 2000 µg/L
worst single sample: 167 µg/L
2/2 SYR4 2014–2017
Fluoride
160.74 µg/L 4%
of the EPA limit 4000 µg/L
worst single sample: 169 µg/L
2/2 SYR4 2014–2017
Nitrate
56 µg/L 0.6%
of the EPA limit 10000 µg/L
 2/16 SYR4 2012–2019
Cyanide
250 µg/L 125%
of the EPA limit, at the 95th percentile of samples — 200 µg/L
 1/2 SYR4 2015–2017
Chloroform
1.3 µg/L
No EPA limit set
 1/1 SYR4 2014
Chromium
1 µg/L 1%
of the EPA limit 100 µg/L
 1/2 SYR4 2014–2017
Gross Alpha, Excl. Radon And U
2.2 pCi/L 15%
of the EPA limit 15 pCi/L
 1/1 SYR4 2018
Mercury
0.2000 µg/L 10%
of the EPA limit 2 µg/L
 1/2 SYR4 2014–2017
Nitrate-Nitrite
412 µg/L 4.1%
of the EPA limit 10000 µg/L
 1/1 SYR4 2014
Nitrite
412 µg/L 41%
of the EPA limit 1000 µg/L
 1/1 SYR4 2014
56 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromochloromethaneDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMethoxychlorOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
PORTER, ROBERT
Phone
574-292-3943
Email
[email protected]

Frequently asked questions about Culver Water Department

Is Culver Water Department tap water safe to drink?

EPA monitoring detected 16 contaminants in Culver Water Department's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Culver Water Department's water?

EPA monitoring detected Arsenic, Total Haloacetic Acids (HAA5), Copper, TTHM, Lead, and others. The full list with the level and data source for each is above.

How many people does Culver Water Department serve?

Culver Water Department reports serving 1,391 people in Indiana, per its EPA record.

Has Culver Water Department had any water quality violations?

The EPA has 88 violations on file for Culver Water Department, of which 2 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.