Tap WaterIndex

← Kentucky

Tap water quality report

Seymour Water Plant, Lp

EPA monitoring tested this supplier for 72 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

72
contaminants tested
12
detected
1,560
people served
10
health-based violations
Kentucky rankingsLead in KentuckyPFAS in Kentucky
Water source
Ground water
Ownership
Private
Counties served
Jackson

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

10
health-based violations
72
violations on file
2
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
MCL Health-based Resolved 2011-06-01 → 2011-06-30
MCL Health-based Resolved 2011-06-01 → 2011-06-30
MCL Health-based Resolved 2011-06-01 → 2011-06-30
MCL Health-based Resolved 2011-06-01 → 2011-06-30
MCL Health-based Resolved 2011-06-01 → 2011-06-30
MCL Health-based Resolved 1996-06-01 → 1996-06-30
MCL Health-based Resolved 1996-06-01 → 1996-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
1500 µg/L 15%
of the EPA limit 10000 µg/L
 18/18 SYR4 2012–2019
TTHM
32.665 µg/L 41%
of the EPA limit 80 µg/L
worst single sample: 34.7 µg/L
12/12 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
28.04 µg/L 47%
of the EPA limit 60 µg/L
worst single sample: 29.8 µg/L
12/12 SYR4 2012–2019
Copper
451.1 µg/L 35%
of the EPA limit 1300 µg/L
worst single sample: 650 µg/L
10/10 SYR4 2018
Lead
0.0084 mg/L 56%
of the EPA limit 0.0150 mg/L
 7/7 LCR 2024
Lead
5.15 µg/L 34%
of the EPA limit 15 µg/L
worst single sample: 5.2 µg/L
6/10 SYR4 2018
Barium
98 µg/L 4.9%
of the EPA limit 2000 µg/L
 3/3 SYR4 2014–2017
Fluoride
280.3 µg/L 7%
of the EPA limit 4000 µg/L
worst single sample: 281 µg/L
3/3 SYR4 2014–2017
Arsenic
1.1 µg/L 11%
of the EPA limit 10 µg/L
 1/3 SYR4 2014–2017
Chloroform
2.6 µg/L
No EPA limit set
 1/1 SYR4 2014
Gross Alpha, Excl. Radon And U
0.6500 pCi/L 4.3%
of the EPA limit 15 pCi/L
 1/1 SYR4 2017
Nitrate-Nitrite
538 µg/L 5.4%
of the EPA limit 10000 µg/L
 1/1 SYR4 2018
60 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromochloromethaneDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
KEENEY, KURTIS
Phone
859-912-0109
Email
[email protected]

Frequently asked questions about Seymour Water Plant, Lp

Is Seymour Water Plant, Lp tap water safe to drink?

EPA monitoring detected 12 contaminants in Seymour Water Plant, Lp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Seymour Water Plant, Lp's water?

EPA monitoring detected Nitrate, TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, and others. The full list with the level and data source for each is above.

How many people does Seymour Water Plant, Lp serve?

Seymour Water Plant, Lp reports serving 1,560 people in Kentucky, per its EPA record.

Has Seymour Water Plant, Lp had any water quality violations?

The EPA has 72 violations on file for Seymour Water Plant, Lp, of which 10 are health-based (a contaminant limit or required treatment was breached) and 2 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.