Tap WaterIndex

← Indiana

Tap water quality report

Lanesville Water Works

EPA monitoring tested this supplier for 5 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

5
contaminants tested
5
detected
1,009
people served
8
health-based violations
Indiana rankingsLead in IndianaPFAS in Indiana
Water source
GWP
Ownership
Local government
Counties served
Harrison

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

8
health-based violations
70
violations on file
13
still open
ViolationTypeStatusPeriod
TT Health-based Unaddressed 2024-10-17
TT Health-based Unaddressed 2024-10-17
TT Health-based Unaddressed 2024-10-17
TT Health-based Unaddressed 2024-10-17
MCL Health-based Resolved 2000-10-01 → 2000-10-31
MCL Health-based Resolved 2000-10-01 → 2000-10-31
MCL Health-based Resolved 2000-10-01 → 2000-10-31
MCL Health-based Resolved 2000-10-01 → 2000-10-31
Other Monitoring Unaddressed 2025-12-02
Other Monitoring Unaddressed 2025-10-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
22 µg/L 28%
of the EPA limit 80 µg/L
worst single sample: 25 µg/L
34/35 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
11.13 µg/L 19%
of the EPA limit 60 µg/L
worst single sample: 12 µg/L
28/35 SYR4 2013–2019
Copper
704.7 µg/L 54%
of the EPA limit 1300 µg/L
worst single sample: 747 µg/L
10/10 SYR4 2018
Lead
0.0071 mg/L 47%
of the EPA limit 0.0150 mg/L
 7/7 LCR 2024
Lead
3.2 µg/L 21%
of the EPA limit 15 µg/L
worst single sample: 3.4 µg/L
5/10 SYR4 2018

Utility contact

Contact
TIDSTROM, THOMAS
Phone
812-952-2057
Email
[email protected]

Frequently asked questions about Lanesville Water Works

Is Lanesville Water Works tap water safe to drink?

EPA monitoring detected 5 contaminants in Lanesville Water Works's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Lanesville Water Works's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Copper, Lead, Lead. The full list with the level and data source for each is above.

How many people does Lanesville Water Works serve?

Lanesville Water Works reports serving 1,009 people in Indiana, per its EPA record.

Has Lanesville Water Works had any water quality violations?

The EPA has 70 violations on file for Lanesville Water Works, of which 8 are health-based (a contaminant limit or required treatment was breached) and 13 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.