Tap WaterIndex

← Illinois

Tap water quality report

Balmoral Heights Subdivision

EPA monitoring tested this supplier for 50 contaminants and detected 7. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
7
detected
400
people served
0
health-based violations
Illinois rankingsLead in IllinoisPFAS in Illinois
Water source
Ground water
Ownership
Private
Counties served
Will

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
7
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2011-07-01 → 2011-09-30
MR Monitoring Resolved 2011-07-01 → 2011-09-30
MR Monitoring Resolved 2011-01-02
MR Monitoring Resolved 2011-01-02
MR Monitoring Resolved 2010-07-01 → 2010-09-30
MR Monitoring Resolved 2010-07-01 → 2010-09-30
MR Monitoring Archived 1977-06-30 → 1981-06-29

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0039 mg/L 26%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2025
Copper
1257.5 µg/L 97%
of the EPA limit 1300 µg/L
worst single sample: 1340 µg/L
12/15 SYR4 2013–2019
Arsenic
5.1525 µg/L 52%
of the EPA limit 10 µg/L
worst single sample: 5.33 µg/L
6/6 SYR4 2012–2018
Barium
199.5 µg/L 10%
of the EPA limit 2000 µg/L
worst single sample: 202 µg/L
6/6 SYR4 2012–2018
Fluoride
1131.5 µg/L 28%
of the EPA limit 4000 µg/L
worst single sample: 1190 µg/L
6/6 SYR4 2012–2018
Combined Radium (-226 And -228)
1.952 pCi/L 39%
of the EPA limit 5 pCi/L
worst single sample: 1.97 pCi/L
2/2 SYR4 2015
Lead
5.17 µg/L 34%
of the EPA limit 15 µg/L
 1/15 SYR4 2013–2019
43 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalBenzeneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCyanideCadmiumCarbon TetrachlorideChloroformChromiumDichloromethaneDibromoacetic AcidDibromochloromethaneDichloroacetic AcidEthylbenzeneMercuryMonobromoacetic AcidMonochloroacetic AcidNitrateNitrate-NitriteNitriteSeleniumStyreneTTHMTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
EMERY, RONALD L
Phone
779-801-4435
Email
[email protected]

Frequently asked questions about Balmoral Heights Subdivision

Is Balmoral Heights Subdivision tap water safe to drink?

EPA monitoring detected 7 contaminants in Balmoral Heights Subdivision's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Balmoral Heights Subdivision's water?

EPA monitoring detected Lead, Copper, Arsenic, Barium, Fluoride, and others. The full list with the level and data source for each is above.

How many people does Balmoral Heights Subdivision serve?

Balmoral Heights Subdivision reports serving 400 people in Illinois, per its EPA record.

Has Balmoral Heights Subdivision had any water quality violations?

The EPA has 7 violations on file for Balmoral Heights Subdivision, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.