Is South Ridge Mhc Tap Water Safe? Quality Report

Water source: GWP
Ownership: Private
Counties served: Will

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
Other	Monitoring	Resolved	2025-07-01
Other	Monitoring	Resolved	2025-07-01
Other	Monitoring	Unaddressed	2023-11-05
Other	Monitoring	Unaddressed	2023-11-05
MON	Monitoring	Resolved	2022-09-01 → 2022-09-30
MON	Monitoring	Resolved	2022-09-01 → 2022-09-30
MON	Monitoring	Resolved	2022-09-01 → 2022-09-30
MR	Monitoring	Resolved	2022-07-01 → 2022-09-30
MR	Monitoring	Resolved	2022-07-01 → 2022-09-30
MR	Monitoring	Resolved	2022-07-01 → 2022-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	12/12	LCR	2025
Copper	826 µg/L 64% of the EPA limit 1300 µg/L worst single sample: 880 µg/L	10/15	SYR4	2013–2019
Bromodichloromethane	2.1069 µg/L No EPA limit set worst single sample: 2.18 µg/L	3/3	SYR4	2013–2017
Chloroform	1.8024 µg/L No EPA limit set worst single sample: 1.85 µg/L	3/3	SYR4	2013–2017
Dibromoacetic Acid	1.687 µg/L No EPA limit set worst single sample: 1.73 µg/L	3/3	SYR4	2013–2017
Dibromochloromethane	2.1237 µg/L No EPA limit set worst single sample: 2.2 µg/L	3/3	SYR4	2013–2017
TTHM	6.006 µg/L 7.5% of the EPA limit 80 µg/L worst single sample: 6.2 µg/L	3/3	SYR4	2013–2017
Total Haloacetic Acids (HAA5)	1.687 µg/L 2.8% of the EPA limit 60 µg/L worst single sample: 1.73 µg/L	3/3	SYR4	2013–2017
Lead	1.6 µg/L 11% of the EPA limit 15 µg/L	1/15	SYR4	2013–2019

5 contaminants tested, none detected

BromoformDichloroacetic AcidMonobromoacetic AcidMonochloroacetic AcidTrichloroacetic Acid

Utility contact

Contact: REEVES, KIRK
Phone: 815-474-1010
Email: [email protected]

Frequently asked questions about South Ridge Mhc

Is South Ridge Mhc tap water safe to drink?

EPA monitoring detected 9 contaminants in South Ridge Mhc's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in South Ridge Mhc's water?

EPA monitoring detected Lead, Copper, Bromodichloromethane, Chloroform, Dibromoacetic Acid, and others. The full list with the level and data source for each is above.

How many people does South Ridge Mhc serve?

South Ridge Mhc reports serving 96 people in Illinois, per its EPA record.

Has South Ridge Mhc had any water quality violations?

The EPA has 16 violations on file for South Ridge Mhc, of which 0 are health-based (a contaminant limit or required treatment was breached) and 2 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.