Tap WaterIndex

← Illinois

Tap water quality report

Fawn Hills Subdivision

EPA monitoring tested this supplier for 78 contaminants and detected 14. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

78
contaminants tested
14
detected
183
people served
2
health-based violations
Illinois rankingsLead in IllinoisPFAS in Illinois
Water source
Ground water
Ownership
Private
Counties served
Peoria

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

2
health-based violations
23
violations on file
1
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 1996-06-01 → 1996-06-30
MCL Health-based Archived 1996-06-01 → 1996-06-30
Other Monitoring Resolved 2025-07-01
Other Monitoring Resolved 2025-07-01
Other Monitoring Unaddressed 2025-07-01
MR Monitoring Resolved 1999-01-01 → 1999-03-31
MR Monitoring Resolved 1999-01-01 → 1999-03-31
MR Monitoring Resolved 1999-01-01 → 1999-03-31
MR Monitoring Archived 1998-12-01 → 1998-12-31
MR Monitoring Archived 1998-12-01 → 1998-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
5400 µg/L 54%
of the EPA limit 10000 µg/L
worst single sample: 5600 µg/L
76/76 SYR4 2012–2019
Copper
247 µg/L 19%
of the EPA limit 1300 µg/L
worst single sample: 310 µg/L
15/15 SYR4 2013–2019
Lead
0.00060 mg/L 4%
of the EPA limit 0.0150 mg/L
 15/15 LCR 2025
Lead
10.4 µg/L 69%
of the EPA limit 15 µg/L
worst single sample: 11 µg/L
9/15 SYR4 2013–2019
Barium
61.9 µg/L 3.1%
of the EPA limit 2000 µg/L
worst single sample: 62 µg/L
3/3 SYR4 2012–2018
Nitrate-Nitrite
5520 µg/L 55%
of the EPA limit 10000 µg/L
worst single sample: 5600 µg/L
3/3 SYR4 2012–2018
Bromodichloromethane
5.28315 µg/L
No EPA limit set
worst single sample: 5.457 µg/L
2/3 SYR4 2012–2017
Bromoform
2.0973 µg/L
No EPA limit set
worst single sample: 2.13 µg/L
2/3 SYR4 2012–2017
Chloroform
5.65595 µg/L
No EPA limit set
worst single sample: 5.891 µg/L
2/3 SYR4 2012–2017
Dibromochloromethane
5.0232 µg/L
No EPA limit set
worst single sample: 5.186 µg/L
2/3 SYR4 2012–2017
Fluoride
635.65 µg/L 16%
of the EPA limit 4000 µg/L
worst single sample: 645 µg/L
2/3 SYR4 2012–2018
TTHM
17.471 µg/L 22%
of the EPA limit 80 µg/L
worst single sample: 18.01 µg/L
2/3 SYR4 2012–2017
Arsenic
2.7 µg/L 27%
of the EPA limit 10 µg/L
 1/3 SYR4 2012–2018
Combined Radium (-226 And -228)
1.28 pCi/L 26%
of the EPA limit 5 pCi/L
 1/1 SYR4 2016
64 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Total Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
BOYLE, ANDY
Phone
309-635-7227
Email
[email protected]

Frequently asked questions about Fawn Hills Subdivision

Is Fawn Hills Subdivision tap water safe to drink?

EPA monitoring detected 14 contaminants in Fawn Hills Subdivision's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Fawn Hills Subdivision's water?

EPA monitoring detected Nitrate, Copper, Lead, Lead, Barium, and others. The full list with the level and data source for each is above.

How many people does Fawn Hills Subdivision serve?

Fawn Hills Subdivision reports serving 183 people in Illinois, per its EPA record.

Has Fawn Hills Subdivision had any water quality violations?

The EPA has 23 violations on file for Fawn Hills Subdivision, of which 2 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.