Tap WaterIndex

← Illinois

Tap water quality report

Kinkaid Area Water

EPA monitoring tested this supplier for 77 contaminants and detected 18. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

77
contaminants tested
18
detected
1
people served
22
health-based violations
Illinois rankingsLead in IllinoisPFAS in Illinois
Water source
Surface water
Ownership
Local government
Counties served
Jackson

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

22
health-based violations
37
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2010-01-01 → 2010-01-31
MCL Health-based Resolved 2010-01-01 → 2010-01-31
MCL Health-based Resolved 2010-01-01 → 2010-01-31
MCL Health-based Resolved 2010-01-01 → 2010-01-31
MCL Health-based Resolved 2010-01-01 → 2010-01-31
TT Health-based Resolved 2003-01-01 → 2003-03-31
TT Health-based Resolved 2003-01-01 → 2003-03-31
TT Health-based Resolved 2003-01-01 → 2003-03-31
TT Health-based Resolved 2003-01-01 → 2003-03-31
TT Health-based Resolved 2003-01-01 → 2003-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Chlorite
733.5 µg/L 73%
of the EPA limit 1000 µg/L
worst single sample: 880 µg/L
114/114 SYR4 2012–2019
Atrazine
1.375 µg/L 46%
of the EPA limit 3 µg/L
worst single sample: 2.2 µg/L
36/36 SYR4 2012–2019
Simazine
0.2600 µg/L 6.5%
of the EPA limit 4 µg/L
worst single sample: 0.3000 µg/L
28/35 SYR4 2012–2019
Bromodichloromethane
4.33 µg/L
No EPA limit set
worst single sample: 4.5 µg/L
18/18 SYR4 2012–2019
Chloroform
38.405 µg/L
No EPA limit set
worst single sample: 42.4 µg/L
18/18 SYR4 2012–2019
Dichloroacetic Acid
25.025 µg/L
No EPA limit set
worst single sample: 31.4 µg/L
16/16 SYR4 2012–2019
TTHM
43.375 µg/L 54%
of the EPA limit 80 µg/L
worst single sample: 45.4 µg/L
16/16 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
53.525 µg/L 89%
of the EPA limit 60 µg/L
worst single sample: 59 µg/L
16/16 SYR4 2012–2019
Trichloroacetic Acid
23.55 µg/L
No EPA limit set
worst single sample: 25.5 µg/L
16/16 SYR4 2012–2019
Nitrate
140 µg/L 1.4%
of the EPA limit 10000 µg/L
 14/16 SYR4 2012–2019
Fluoride
980 µg/L 25%
of the EPA limit 4000 µg/L
worst single sample: 1020 µg/L
11/11 SYR4 2012–2019
2,4-D
0.9200 µg/L 1.3%
of the EPA limit 70 µg/L
worst single sample: 1.1 µg/L
7/25 SYR4 2012–2019
Nitrate-Nitrite
122 µg/L 1.2%
of the EPA limit 10000 µg/L
worst single sample: 140 µg/L
7/8 SYR4 2012–2019
Monobromoacetic Acid
4.425 µg/L
No EPA limit set
worst single sample: 4.8 µg/L
6/16 SYR4 2012–2019
Monochloroacetic Acid
3.21 µg/L
No EPA limit set
worst single sample: 3.3 µg/L
4/16 SYR4 2012–2019
Combined Radium (-226 And -228)
1.05 pCi/L 21%
of the EPA limit 5 pCi/L
 1/1 SYR4 2015
Dibromochloromethane
0.5000 µg/L
No EPA limit set
 1/18 SYR4 2012–2019
Ethylene Dibromide
0.0200 µg/L 40%
of the EPA limit 0.0500 µg/L
 1/14 SYR4 2012–2019
59 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TPAntimony, TotalArsenicBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebDiquatEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WILMOUTH, SCOTT A
Phone
618-687-2951
Email
[email protected]

Frequently asked questions about Kinkaid Area Water

Is Kinkaid Area Water tap water safe to drink?

EPA monitoring detected 18 contaminants in Kinkaid Area Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Kinkaid Area Water's water?

EPA monitoring detected Chlorite, Atrazine, Simazine, Bromodichloromethane, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Kinkaid Area Water serve?

Kinkaid Area Water reports serving 1 people in Illinois, per its EPA record.

Has Kinkaid Area Water had any water quality violations?

The EPA has 37 violations on file for Kinkaid Area Water, of which 22 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.