← Illinois

Tap water quality report

Galva

EPA monitoring tested this supplier for 78 contaminants and detected 18. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

78
contaminants tested
18
detected
2,449
people served
153
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Henry

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

153
health-based violations
170
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2004-04-01 → 2004-06-30
MCL Health-based Resolved 2004-04-01 → 2004-06-30
MCL Health-based Resolved 2004-04-01 → 2004-06-30
MCL Health-based Resolved 2004-04-01 → 2004-06-30
MCL Health-based Resolved 2004-04-01 → 2004-06-30
MCL Health-based Resolved 2004-04-01 → 2004-06-30
MCL Health-based Resolved 2004-01-01 → 2004-03-31
MCL Health-based Resolved 2004-01-01 → 2004-03-31
MCL Health-based Resolved 2004-01-01 → 2004-03-31
MCL Health-based Resolved 2004-01-01 → 2004-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
99.1 µg/L 7.6%
of the EPA limit 1300 µg/L
worst single sample: 140 µg/L
30/30 SYR4 2012–2018
Nitrate
185.5 µg/L 1.9%
of the EPA limit 10000 µg/L
worst single sample: 190 µg/L
30/32 SYR4 2012–2019
Combined Radium (-226 And -228)
2.75 pCi/L 55%
of the EPA limit 5 pCi/L
worst single sample: 3.29 pCi/L
21/21 SYR4 2012–2019
Fluoride
2521 µg/L 63%
of the EPA limit 4000 µg/L
worst single sample: 2540 µg/L
20/20 SYR4 2012–2019
Lead
0.0016 mg/L 11%
of the EPA limit 0.0150 mg/L
18/18 LCR 2025
Lead
11.92 µg/L 79%
of the EPA limit 15 µg/L
worst single sample: 18 µg/L
9/30 SYR4 2012–2018
Bromodichloromethane
3.211 µg/L
No EPA limit set
worst single sample: 3.47 µg/L
8/8 SYR4 2013–2019
Bromoform
16.2575 µg/L
No EPA limit set
worst single sample: 16.45 µg/L
8/8 SYR4 2013–2019
Dibromoacetic Acid
3.552 µg/L
No EPA limit set
worst single sample: 3.93 µg/L
8/8 SYR4 2013–2019
Dibromochloromethane
10.2695 µg/L
No EPA limit set
worst single sample: 10.7 µg/L
8/8 SYR4 2013–2019
TTHM
28.945 µg/L 36%
of the EPA limit 80 µg/L
worst single sample: 29.4 µg/L
8/8 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
5.865 µg/L 9.8%
of the EPA limit 60 µg/L
worst single sample: 6.6 µg/L
8/8 SYR4 2013–2019
Barium
28.4 µg/L 1.4%
of the EPA limit 2000 µg/L
worst single sample: 29 µg/L
5/5 SYR4 2012–2018
Arsenic
2.97 µg/L 30%
of the EPA limit 10 µg/L
worst single sample: 3.1 µg/L
3/5 SYR4 2012–2018
Chloroform
0.5902 µg/L
No EPA limit set
worst single sample: 0.5930 µg/L
2/8 SYR4 2013–2019
Monobromoacetic Acid
2.6215 µg/L
No EPA limit set
worst single sample: 2.67 µg/L
2/8 SYR4 2013–2019
Selenium
5.075 µg/L 10%
of the EPA limit 50 µg/L
worst single sample: 5.2 µg/L
2/5 SYR4 2012–2018
Chromium
4.6 µg/L 4.6%
of the EPA limit 100 µg/L
1/5 SYR4 2012–2018
60 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDichloroacetic AcidDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
DYER, DAVID L.
Phone
309-932-2555
Email
[email protected]

Frequently asked questions about Galva

Is Galva tap water safe to drink?

EPA monitoring detected 18 contaminants in Galva's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Galva's water?

EPA monitoring detected Copper, Nitrate, Combined Radium (-226 And -228), Fluoride, Lead, and others. The full list with the level and data source for each is above.

How many people does Galva serve?

Galva reports serving 2,449 people in Illinois, per its EPA record.

Has Galva had any water quality violations?

The EPA has 170 violations on file for Galva, of which 153 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.