Tap WaterIndex

← Illinois

Tap water quality report

Linway Estates Mhp

EPA monitoring tested this supplier for 50 contaminants and detected 6. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
6
detected
380
people served
0
health-based violations
Illinois rankingsLead in IllinoisPFAS in Illinois
Water source
Ground water
Ownership
Private
Counties served
Cook

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
13
violations on file
1
still open
ViolationTypeStatusPeriod
Other Monitoring Unaddressed 2025-07-01
Other Monitoring Resolved 2025-07-01
Other Monitoring Resolved 2025-07-01
Other Monitoring Resolved 2024-07-01
Other Monitoring Resolved 2024-07-01
MR Monitoring Resolved 2019-01-01 → 2019-12-31
MR Monitoring Resolved 2019-01-01 → 2019-12-31
MR Monitoring Resolved 2019-01-01 → 2019-12-31
MR Monitoring Resolved 2019-01-01 → 2019-12-31
MR Monitoring Resolved 2019-01-01 → 2019-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2024
Combined Radium (-226 And -228)
3.85 pCi/L 77%
of the EPA limit 5 pCi/L
worst single sample: 4 pCi/L
6/6 SYR4 2012–2018
Barium
49.955 µg/L 2.5%
of the EPA limit 2000 µg/L
worst single sample: 50 µg/L
4/4 SYR4 2014–2017
Fluoride
398.8 µg/L 10%
of the EPA limit 4000 µg/L
worst single sample: 400 µg/L
4/4 SYR4 2014–2017
Dichloroacetic Acid
1.285 µg/L
No EPA limit set
worst single sample: 1.3 µg/L
2/3 SYR4 2012–2017
Total Haloacetic Acids (HAA5)
1.285 µg/L 2.1%
of the EPA limit 60 µg/L
worst single sample: 1.3 µg/L
2/3 SYR4 2012–2017
44 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicBenzeneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChloroformChromiumDichloromethaneDibromoacetic AcidDibromochloromethaneEthylbenzeneLeadMercuryMonobromoacetic AcidMonochloroacetic AcidNitrateNitrate-NitriteNitriteSeleniumStyreneTTHMTetrachloroethyleneThallium, TotalTolueneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
HARTMAN, MARK
Phone
618-610-3099
Email
[email protected]

Frequently asked questions about Linway Estates Mhp

Is Linway Estates Mhp tap water safe to drink?

EPA monitoring detected 6 contaminants in Linway Estates Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Linway Estates Mhp's water?

EPA monitoring detected Lead, Combined Radium (-226 And -228), Barium, Fluoride, Dichloroacetic Acid, and others. The full list with the level and data source for each is above.

How many people does Linway Estates Mhp serve?

Linway Estates Mhp reports serving 380 people in Illinois, per its EPA record.

Has Linway Estates Mhp had any water quality violations?

The EPA has 13 violations on file for Linway Estates Mhp, of which 0 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.