Is Martinsville Tap Water Safe? Quality Report

Water source: GWP
Ownership: Local government
Counties served: Clark

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2015-08-01 → 2015-08-31
MCL	Health-based	Resolved	2015-08-01 → 2015-08-31
MCL	Health-based	Resolved	2015-08-01 → 2015-08-31
MCL	Health-based	Resolved	2015-08-01 → 2015-08-31
MCL	Health-based	Resolved	2005-07-01 → 2005-09-30
MCL	Health-based	Resolved	2005-07-01 → 2005-09-30
MCL	Health-based	Resolved	2005-07-01 → 2005-09-30
MCL	Health-based	Resolved	2005-07-01 → 2005-09-30
MCL	Health-based	Resolved	2005-07-01 → 2005-09-30
MCL	Health-based	Resolved	2005-07-01 → 2005-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Copper	360.8 µg/L 28% of the EPA limit 1300 µg/L worst single sample: 560 µg/L	27/40	SYR4	2012–2019
Lead	0.0114 mg/L 76% of the EPA limit 0.0150 mg/L	19/19	LCR	2025
Lead	13.0395 µg/L 87% of the EPA limit 15 µg/L worst single sample: 19 µg/L	14/40	SYR4	2012–2019
Bromodichloromethane	5.08 µg/L No EPA limit set worst single sample: 5.2 µg/L	7/7	SYR4	2014–2019
Chloroform	7.8256 µg/L No EPA limit set worst single sample: 8.098 µg/L	7/7	SYR4	2014–2019
Dibromochloromethane	4.03 µg/L No EPA limit set worst single sample: 4.3 µg/L	7/7	SYR4	2014–2019
TTHM	16.636 µg/L 21% of the EPA limit 80 µg/L worst single sample: 16.9 µg/L	7/7	SYR4	2014–2019
Total Haloacetic Acids (HAA5)	3.74 µg/L 6.2% of the EPA limit 60 µg/L worst single sample: 3.8 µg/L	5/7	SYR4	2014–2019
Trichloroacetic Acid	2.94 µg/L No EPA limit set worst single sample: 3.1 µg/L	5/7	SYR4	2014–2019
Bromoform	1.255 µg/L No EPA limit set worst single sample: 1.3 µg/L	4/7	SYR4	2014–2019
Dichloroacetic Acid	1.58 µg/L No EPA limit set worst single sample: 1.6 µg/L	2/7	SYR4	2014–2019

3 contaminants tested, none detected

Dibromoacetic AcidMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact: SPIRES, JANA
Phone: 217-382-4323
Email: [email protected]

Frequently asked questions about Martinsville

Is Martinsville tap water safe to drink?

EPA monitoring detected 11 contaminants in Martinsville's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Martinsville's water?

EPA monitoring detected Copper, Lead, Lead, Bromodichloromethane, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Martinsville serve?

Martinsville reports serving 1,200 people in Illinois, per its EPA record.

Has Martinsville had any water quality violations?

The EPA has 51 violations on file for Martinsville, of which 14 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.