Tap WaterIndex

← Illinois

Tap water quality report

Ehlers Mhp

EPA monitoring tested this supplier for 49 contaminants and detected 4. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

49
contaminants tested
4
detected
112
people served
0
health-based violations
Illinois rankingsLead in IllinoisPFAS in Illinois
Water source
Ground water
Ownership
Private
Counties served
Champaign

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
12
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2025-01-01
MR Monitoring Resolved 2025-01-01
MR Monitoring Resolved 2025-01-01
MR Monitoring Resolved 2025-01-01
MR Monitoring Resolved 2020-12-30
MR Monitoring Resolved 2020-12-30
MR Monitoring Resolved 1998-07-01 → 1998-09-30
MR Monitoring Archived 1995-12-01 → 1995-12-31
MR Monitoring Archived 1995-12-01 → 1995-12-31
MR Monitoring Archived 1991-09-01 → 1991-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 20/20 LCR 2025
Barium
58.545 µg/L 2.9%
of the EPA limit 2000 µg/L
worst single sample: 58.6 µg/L
2/2 SYR4 2014–2017
Copper
109 µg/L 8.4%
of the EPA limit 1300 µg/L
 1/10 SYR4 2014–2017
Fluoride
156 µg/L 3.9%
of the EPA limit 4000 µg/L
 1/2 SYR4 2014–2017
45 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicBenzeneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCyanideCadmiumCarbon TetrachlorideChloroformChromiumDichloromethaneDibromoacetic AcidDibromochloromethaneDichloroacetic AcidEthylbenzeneLeadMercuryMonobromoacetic AcidMonochloroacetic AcidNitrateNitrate-NitriteNitriteSeleniumStyreneTTHMTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WALLER, JR., ROBERT D.
Phone
217-643-2355
Email
[email protected]

Frequently asked questions about Ehlers Mhp

Is Ehlers Mhp tap water safe to drink?

EPA monitoring detected 4 contaminants in Ehlers Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Ehlers Mhp's water?

EPA monitoring detected Lead, Barium, Copper, Fluoride. The full list with the level and data source for each is above.

How many people does Ehlers Mhp serve?

Ehlers Mhp reports serving 112 people in Illinois, per its EPA record.

Has Ehlers Mhp had any water quality violations?

The EPA has 12 violations on file for Ehlers Mhp, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.